Cequent Towing Products Signature Series Kurulum Talimatları Kılavuzu - Sayfa 2
Otomobil Aksesuarları Cequent Towing Products Signature Series için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Cequent Towing Products Signature Series 11 sayfaları. 24k 5th wheel hitch
Ayrıca Cequent Towing Products Signature Series için: Kullanım Talimatları Kılavuzu (9 sayfalar)
Sayfayı Yazdır5. Trucks come in many different configurations. Cequent Towing Products hitches are designed for use in light trucks such as
the Ford F-Series, the Chevy Silverado and the Dodge Ram. Cequent Towing Products recommends the use of long bed (8ft)
light trucks for the best combination in truck - trailer turning clearance.
Rule of thumb:
Figure 3.
6. If a short bed pickup (less than 8 ft. but longer than 6 ft.) is to be used for towing, Cequent Towing Products recommends the
trailer be equipped with an extended pin box to help gain additional truck - trailer turning clearance (See trailer manufacturer for
options), Figure 4. It also may be helpful to add a
speed, non-highway maneuvering.
Figure 4.
Conventional Pin Box
Do Not install this fifth wheel hitch on or attempt to tow with a short bed pickup
truck that has a bed shorter than 6 ft.!
7. The height of the hitch and the pin box should be adjusted so the trailer is approximately level as it is towed. Allow
approximately 6 inches clearance between the top of the pickup walls and the underside of the front of the trailer for pitch and
roll of the trailer, Figure 5. Allow more clearance between pickup walls and trailer for off road use.
Figure 5.
The measurements above are guidelines. If your measurements are close to these numbers re-check clearances.
If vehicle and/or trailer has any added bed vicinity accessories (i.e. fairings, air dams, ground effects, bed rails, etc.).
Additional dimensioning and clearance checks have to be made.
z
2006, 2007 Cequent Towing Products
Installation Instructions
READ THOROUGHLY BEFORE BEGINNING
Signature Series Rail Kit
Dodge Ram Trucks-all, including Mega-cabs
The distance from the back of the truck cab to the center of the rear truck
axle ("X" in Figure 3), should be approximately 4 inches greater than one-half
the trailer width ("Y" in Figure 3).
TRUCK
Signature Series
Slider (Part # 30070) for increased turning clearance for low
Extended Pin Box
WARNING:
Approximately 6 Inches
Level Trailer
CAUTION:
Sheet 2 of 11
Part Numbers:
RV TRAILER
KING PIN
30074N
6-27-07
30074
Rev. F