Ganz Thermal ZNT6-H Hızlı Başlangıç Kılavuzu - Sayfa 6

IP Kamera Ganz Thermal ZNT6-H için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Ganz Thermal ZNT6-H 11 sayfaları. Fixed camera

Fixed Camera Quick Start Guide

Tighten the gland nut onto the gland housing. Leave about 5 inches

of cable sticking out of the gland housing

Insert the cable and gland into the camera. Connect the Analog

cable and CAT5 cable to the camera. Slide the gland housing-to-

chassis nut over the cables. Tighten the gland housing-to-chassis

nut into the camera

Not shown, crimp the other end of the cables in place (not shown).

For all Configurations:

Pull the cable(s) taut back through the IP Camera, exposing the

thread of the cable sealing gland out of the base of the IP Camera

Assemble the Electrical Nut back onto the gland and tighten the

Nut securely until it is finger tight. Use a flat head screwdriver to

continue turning the electrical nut to approximately 50 in-lbs. of

torque

Assembling the Fixed Mount Camera

Using 8 of the #6 screws, assemble the Base Mount adapter (or

newer hybrid mount), to the IP Camera. Tighten the 8 fasteners to

approximately 10 in-lbs. of torque with the Electric Screw Driver,

and T10 Security bit or Phillips #2 bit depending on screws

provided

10. Using 4 of the #6 screws, assemble the optional Standard 4 hole

Mount, to the Base Mount, and tighten the fasteners to

approximately 10 in-lbs. of torque with the Electric Screw Driver,

and T10 Security bit or Phillips #2 bit depending on screws

provided.

11. Connect the cable(s) to the respective connector:

www.ganzsecurity.com

November 2014

Ethernet: Ethernet Port

Analog: Analog Video Out (Fixed Mount 320x240 &

640x480 Only)

AC/DC Power for Fixed Mount 320x240 and 640x480:

Connect wires to power block according the pin-out

shown on the next page and described below:

If powering the camera with an AC supply,

connect AC+ to the 24VAC input and the AC- to

the 12VDC input.

ii.

If powering the camera with a DC supply,

connect the DC+ to the 12VDC input and the

DC- (or ground) to the GND DC- (or ground) to

the GND input.