HIKVISION DS-2CE17U8T-IT Kullanıcı Kılavuzu - Sayfa 3
DVR HIKVISION DS-2CE17U8T-IT için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. HIKVISION DS-2CE17U8T-IT 14 sayfaları. Turbohd 4k series bullet camera
Ayrıca HIKVISION DS-2CE17U8T-IT için: Kullanıcı Kılavuzu (16 sayfalar), Hızlı Başlangıç Kılavuzu (17 sayfalar)
![HIKVISION DS-2CE17U8T-IT Kullanıcı Kılavuzu](/uploads/products/server2/2083410/2083410.jpg)
Safety Instruction
These instructions are intended to ensure that user can
use the product correctly to avoid danger or property
loss.
The precaution measure is divided into "Warnings" and
"Cautions".
Warnings: Serious injury or death may occur if any of
the warnings are neglected.
Cautions: Injury or equipment damage may occur if any
of the cautions are neglected.
Warnings Follow
these safeguards to
prevent serious injury
or death.
Warnings
In the use of the device, you must be in strict
compliance with the electrical safety regulations of
the nation and region.
Input voltage should meet both the SELV (Safety Extra
Low Voltage) and the Limited Power Source with 12
VDC according to the IEC60950-1 standard. Refer to
technical specifications for detailed information.
The maximum output current is 6A protected by the
internal circuit.
Do not connect multiple devices to one power
adapter to avoid over-heating or a fire hazard caused
by overload.
Make sure that the plug is firmly connected to the
power socket.
Make sure that the device is firmly fixed if wall
mounting or ceiling mounting is adopted.
If smoke, odor or noise rise from the device, turn off
the power at once and unplug the power cord, and
then contact the service center.
Never attempt to disassemble the camera by
unprofessional personal.
Cautions
Do not drop the camera or subject it to physical
shock.
Do not touch senor modules with fingers.
Do not place the camera in extremely hot, cold (the
operating temperature shall be -40°C to 60°C), dusty
or damp locations, and do not expose it to high
electromagnetic radiation.
If cleaning is necessary, use clean cloth with a bit of
ethanol and wipe it gently.
Do not aim the camera at the sun or extra bright
places.
The sensor may be burned out by a laser beam, so
when any laser equipment is in using, make sure that
the surface of sensor will not be exposed to the laser
beam.
Do not expose the device to high electromagnetic
radiation or extremely hot, cold, dusty or damp
environment.
Cautions Follow these
precautions to prevent
potential injury or
material damage.