IKEA LAGAN Manuel - Sayfa 39

Bulaşık Makinesi IKEA LAGAN için çevrimiçi göz atın veya pdf Manuel indirin. IKEA LAGAN 48 sayfaları. Examples of the load of the basket
Ayrıca IKEA LAGAN için: Montaj Talimatları Kılavuzu (8 sayfalar), Kullanıcı Kılavuzu (20 sayfalar), Kullanıcı Kılavuzu (16 sayfalar), Kullanıcı Kılavuzu (20 sayfalar), Talimatlar Kılavuzu (48 sayfalar), Kullanıcı Kılavuzu (16 sayfalar), Kullanıcı Kılavuzu (24 sayfalar), Manuel (28 sayfalar), Kullanım Kılavuzu (24 sayfalar), Kullanıcı Kılavuzu (24 sayfalar), Manuel (24 sayfalar), Manuel (4 sayfalar), Kullanıcı Kılavuzu (12 sayfalar), Manuel (24 sayfalar), Montaj Talimatları Kılavuzu (20 sayfalar), Kurulum Kılavuzu (20 sayfalar), Manuel (28 sayfalar), Manuel (32 sayfalar), Manuel (44 sayfalar), Manuel (16 sayfalar), Manuel (16 sayfalar), Manuel (24 sayfalar), Manuel (28 sayfalar), Manuel (28 sayfalar), Kullanıcı Kılavuzu (28 sayfalar), Manuel (40 sayfalar), Manuel (48 sayfalar), Kullanım ve Bakım Kılavuzu (25 sayfalar), Manuel (44 sayfalar), Manuel (40 sayfalar), Manuel (28 sayfalar), Manuel (28 sayfalar), Kullanıcı Kılavuzu (24 sayfalar), Manuel (48 sayfalar), Kullanıcı Kılavuzu (16 sayfalar), Kurulum Talimatları Kılavuzu (18 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar), Kurulum Talimatları Kılavuzu (16 sayfalar), Manuel (28 sayfalar), Manuel (28 sayfalar), Manuel (44 sayfalar), Manuel (48 sayfalar), Manuel (16 sayfalar), Manuel (32 sayfalar), Manuel (24 sayfalar), Manuel (25 sayfalar), Manuel (18 sayfalar), Kullanıcı Kılavuzu (28 sayfalar), Manuel (44 sayfalar), Manuel (24 sayfalar), Manuel (32 sayfalar), Manuel (18 sayfalar), Manuel (48 sayfalar), Manuel (29 sayfalar), Manuel (29 sayfalar), Manuel (34 sayfalar), Kurulum Talimatları Kılavuzu (42 sayfalar)

Sayfayı Yazdır

ENGLISH

Electrical connection

Warning! Refer to Safety

chapters.

Connection cable

Caution! Information for

authorised installer only.

Warning!

The appliance must be earthed.

Warning!

Risk of injury from electrical

current.

• The electrical mains terminal is under

voltage.

• Make sure that the electrical mains

terminal is free of voltage.

• Loose and inappropriate plug and socket

connections. May overheat the terminal.

• Make sure that the clamping connections

are installed correctly.

• Secure the cable with the strain relief

clamp.

Before connecting, check that the nominal

voltage of the appliance stated on the rating

plate, corresponds to the available supply

voltage. Also, check the power rating of the

appliance and make sure that the wire is

suitably sized to suit the appliance power

rating. Refer to the Technical data chapter.

The rating plate is located below the surface

of the casing.

The appliance is supplied with a connection

cable. The cable must be provided with a

proper plug, which supports the load

marked on the identification plate. Refer to

the Technical data chapter.

The plug has to be fitted in a proper socket.

If connecting the appliance directly to the

electric system, it is necessary that you

install a double pole switch between the

appliance and the electricity supply, with a

minimum gap of 3 mm between the switch

contacts. The double pole has to be of a type

suitable for the required load in compliance

with the current rules.

The connection cable has to be placed in

order that, in each part, it cannot reach a

90 °C temperature. The blue neutral cable

must be connected to the terminal block

marked with "N". The brown or black phase

cable, fitted in the terminal block contact

marked with "L", must always be connected

to the live phase.

Electrical Requirements

You can check the parameters of

adjustment setting for this

appliance on the rating plate.

Refer to the Technical data

chapter.

The manufacturer declines any

liability if these safety measures

are not observed.

This hob is designed to be connected to a

220-240 V 50-60 Hz AC electrical supply.

Before switching on, make sure the

electricity supply voltage is the same as that

indicated on the hob rating plate. The rating

plate is located below the surface of the

casing.

The hob is supplied with a 3 core flexible

supply cord.

Upon completion there must be no cut, or

stray strands of wire present and the cord

clamp must be secure over the outer sheath.

Replacement of the connection cable

Warning! To replace the

connection cable, the technician

must have a specific equipment.

In this case, only cable type H03V2V2-F T90

must be used. The cable section must be

suitable to the voltage and the working

temperature. The yellow and green earth