Avantco 178UDD2HCS Kullanıcı Kılavuzu - Sayfa 13

Mutfak Aletleri Avantco 178UDD2HCS için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Avantco 178UDD2HCS 19 sayfaları. Beer dispensers
Ayrıca Avantco 178UDD2HCS için: Kullanıcı Kılavuzu (19 sayfalar), Kullanıcı Kılavuzu (19 sayfalar)

Sayfayı Yazdır

Changing C02 Cylinder

Follow these instructions at ALL times when you replace a CO2 gas cylinder.

Close cylinder at A.

2. Remove tap D from keg. Pull pressure release ring on body of tap to release pressure remaining in line (do

not close C).

3. Remove or loosen regulator key B by turning counter clockwise.

4. Remove regulator from used cilinder at E.

5. Remove dust cap from new gas cylinder at E and clear dust from outlet by opening and closing valve A

quickly using appropriate wrench.

6. Attach regulator to new cylinder at E (use new fiber/plastic washer, if required).

Open valve A all the way.

8. Close valve C.

9. Adjust regulator key B by turning clockwise to set pressure (check setting by opening C and pulling and

releasing the ring F on the pressure release valve on the body of the tap).

10. Tap keg at D with valve C open.

NOTE: DO NOT drop cylinders. DO NOT lay cylinders flat. It requires 1/2 lb. of CO2 to dispense 1/2 barrel of

beer at 38°F with 15 lbs. of pressure on barrel.

Pressure Adjustment on CO2 Regulator

Increasing Pressure:

Close regulator shut-off C.

2. Turn regulator key B clockwise and make setting.

3. Tap gauge for accurate reading.

4. Open regulator shut-off C and draw beer.

Decreasing Pressure:

Close regulator shut-off C.

2. Untap keg at D and activate tap handle to bleed line.

Leave in open position.

3. Slowly open regulator shut-off C and simultaneously

turn regulator key counter-clockwise to zero reading.

4. Close regulator shut-off C and set pressure by turning

regulator key clockwise. Check setting by

opening and closing valve C.

5. Close tap head D (put in OFF position).

6. Tap keg at D and open regulator shut-off C.

User Manual

Beer Dispensers