HIKVISION DS-7104HQHI-K1 Hızlı Başlangıç Kılavuzu - Sayfa 8
DVR HIKVISION DS-7104HQHI-K1 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. HIKVISION DS-7104HQHI-K1 17 sayfaları. Network/digital video recorder
Ayrıca HIKVISION DS-7104HQHI-K1 için: Hızlı Başlangıç Kılavuzu (17 sayfalar), Hızlı Başlangıç Kılavuzu (8 sayfalar)
Sayfayı Yazdır
Fix-on-Bottom Installation
Fix-on-bottom installation is applicable when it requires to install the HDD at the internal bottom.
Unfasten screws on each panel to remove the device cover. Refer to Figure 2-7.
Connect the data cable and power cable. Refer to Figure 2-8.
Match HDD screw threads with the reserved holes on the device bottom, and fix HDD with screws. Refer
to Figure 2-9.
You can repeat the steps above to install other HDDs.
Reinstall the device cover and fasten screws.
RS-485 and Controller Connection
Use RS- 485 interface to connect PTZ with DVR.
Before you start
Ensure both controller and DVR are grounded.
Pull out the pluggable block at the RS-485 terminal block.
Press and hold the orange part of the pluggable block, insert signal cables into slots.
Release the orange part. Ensure signal cables are in tight.
Connect A+ on PTZ to D+ on terminal block and B- on controller to D- on terminal block. Fasten stop
screws.
Plug pluggable block back into terminal block.
Digital Video Recorder Quick Start Guide
Fix Mounting Ear
Remove Cover
Open Front Panel
Connect Cable
7
Insert HDD
Fix HDD