Jamara 06 1220 Talimatlar Kılavuzu - Sayfa 13

Verici Jamara 06 1220 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Jamara 06 1220 16 sayfaları. 2,4 ghz
Ayrıca Jamara 06 1220 için: Talimatlar Kılavuzu (16 sayfalar), Talimatlar Kılavuzu (16 sayfalar)

Sayfayı Yazdır
Jamara 06 1220 Talimatlar Kılavuzu
GB - Problems and solution
Problem
Transmitterdoes not turn ON
Transmitter wll not bind to receiver
Receiver won´t power ON
Audible alarm beeps continuously
Servos movement is slow
Trim Switch
Inadequate transmitting range
Servo(s) move the wrong direction
Servo Horn(s) not centered
Control linkage(s) bind
Model steers right or left without
control input
Throttle servo or ESC moves to
programmed position without input
Cause
Batteries not installed correctly
Batteries are dead
There´s an internal problem
Too much time elalpsed after pressing
receiver Bind Button
Attempting to bind incompatible receiver
Using electronic speed control
Batteries not installed correctly
Batteries dead
Loose Switch connection
Low transmitter battery voltage
Low receiver battery voltage
Control linkages are not working properly Adjust control linkage to operate smoothly
Trim is outside of operational range
Low transmitter battery voltage
Low receiver battery voltage
Receiver antenna not mounted correctly
in your model
Incorrect Servo Reversing setting
Servo Horn(s) not centered
Servo Sub- Trim out of adjustment
To much servo travel
Streering out of trim
Throttle out of trim
Solution
Reinstal batteries, observing correct polarity
Replace batteries
Contact Customer Service
Quickly press the transmitter Bind Button after
releasing the receiver Bind Button
Use only compa 2.4 GHz receivers
Disconnect ESC and use dry cell battery for binding
procedure, then reconnect ESC after binding
Reinstal batteries, observing correct polarity
Replace or recharge batteries
Double-check all connections including switch
Replace or recharge batteries
Replace or recharge receiver batteries
Servo does not move when using
Reset trim to zero and center the servo horn and
control linkages
Replace transmitter batteries
Replace or recharge receiver batteries
Mount receiver antenna as recommended
Change Servo Reversing setting
Servo horn not installed correctly Turn servo horn
180° and reinstall
Adjust Servo Sub- Trim to center servo horn
Decrease servo travel using EPA function
Use steering Trim Switch to adjust Steering Trim so
model drivers straight
Use Throttle Trim Switch to adjust Throttle Neutral
13