Makita 1911B Kullanım Kılavuzu - Sayfa 4
Elektrikli Alet Makita 1911B için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 1911B 18 sayfaları. Power planer
Ayrıca Makita 1911B için: Kullanım Kılavuzu (12 sayfalar), Kullanım Kılavuzu (16 sayfalar), Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (12 sayfalar)
Sayfayı Yazdır
ENGLISH
1 Bolt
2 Drum
3 Planer blade
4 Drum cover
5 Adjust plate
6 Blade edge
7 Screws
8 Heel
9 Back side of gauge base
0 Inside edge of gauge plate
q Gauge plate
SPECIFICATIONS
Model
Planing width ................................................ 110 mm
Planing depth ................................................... 2 mm
No load speed (RPM) .................................... 16,000
Overall length ............................................... 355 mm
Net weight ....................................................... 4.2 kg
• Due to the continuing program of research and
development, the specifications herein are subject
to change without prior notice.
• Note: Specifications may differ from country to
country.
Power supply
The machine should be connected only to a power
supply of the same voltage as indicated on the
nameplate, and can only be operated on single-phase
AC supply. They are double-insulated in accordance
with European Standard and can, therefore, also be
used from sockets without earth wire.
Safety hints
For your own safety, please refer to enclosed Safety
instructions.
These symbols mean:
Read instruction manual.
DOUBLE INSULATION
4
Explanation of general view
w Gauge base
e Knob
r Switch trigger
t Lock button/
Lock-off button
y Start
u End
i ''V'' groove
o Front base
p Align the ''V'' groove with the
edge of the workpiece.
ADDITIONAL SAFETY RULES
1911B
1. Rags, cloth, cord, string and the like should
2. Avoid cutting nails. Inspect for and remove all
3. Handle the blades very carefully.
4. Be sure the blade installation bolts are
5. Hold the machine firmly with both hands.
6. Keep hands away from rotating parts.
7. Before using the machine on an actual work-
8. Make sure the blade is not contacting the
9. Wait until the blade attains full speed before
10. Keep at least 200 mm away from the machine
11. Always switch off and wait for the blades to
12. Never stick your finger into the chip chute.
13. Do not leave the machine running. Operate the
14. When leaving the planer, switch off and set it
15. Always change both blades or covers on the
16. Wait for complete run-down before putting the
17. Use only Makita blades specified in this
SAVE THESE INSTRUCTIONS.
a Sharpening holder
s Wing nut
d Blade (A)
f Blade (B)
g Side (C)
h Side (D)
j Screwdriver
k Nozzle assembly
l Makita vacuum cleaner
never be left around the work area.
nails from the workpiece before operation.
securely tightened before operation.
piece, let it run for a while. Watch for vibration
or wobbling that could indicate poor installa-
tion or a poorly balanced blade.
workpiece before the switch is turned on.
cutting.
at all times.
come to a complete stop before any adjusting.
Chute may jam when cutting damp wood.
Clean out chips with a stick.
machine only when hand-held.
with the front base up on a wooden block, so
that the blades do not contact anything.
drum, otherwise the resulting imbalance will
cause vibration and shorten machine life.
machine aside.
manual.