CORNING 6780-4 Kullanım Kılavuzu - Sayfa 8
Laboratuvar Ekipmanları CORNING 6780-4 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. CORNING 6780-4 13 sayfaları. Digital microplate and orbital shakers
Sayfayı Yazdır
CORNING
LSE
DIGITAL MICROPLATE AND ORBITAL SHAKERS
5.3. ADDITIONAL OPERATIONS
POWER
Rotate the encoder knob ONE CLICK right (+) or left (-) to view the set value for RPM during
the shaking. The RPM signal light will then flash for 2 seconds and the display will show the
set RPM. The RPM and the light will stop flashing after 2 seconds.
NOTE: Shaker must be in RPM mode – RPM signal light must be on.
POWER
Rotate the encoder knob ONE CLICK right (+) or left (-) to view the set value for TIME during
the shaking. The TIME signal will light for 2 seconds and the display will show the set TIME.
After 2 seconds the display will return to the count TIME and the signal light will stop flashing.
NOTE: Shaker must be in TIME mode – TIME signal light must be on.
6.0.
GENERAL PRECAUTIONS
Always plug the unit into a properly grounded and fused outlet.
Do not use the device near water sources. Take care, that water will not fall on the device,
especially during cleaning procedures.
Do not use device in a caustic or explosive atmosphere.
There are no user serviceable parts in the unit. Opening the unit may void the warranty. In
case of a malfunction or liquid being spilled into the unit, unplug the device from its power
outlet and contact Corning Customer Service.
NOTE:
If the device does not function properly, even if you have exactly followed the instructions
described in the User's manual, contact Corning Customer Service at:
1.800.492.1110 (for toll-free calling withing the U.S. and Canada)
1.978.442.2200 (outside the U.S.), or
contact your local Corning support office listed in the back of this manual.
If the equipment is used in a manner not specified by this manual, the equipment may become
unsafe to operate, could harm the user or the device, and may void the warranty.
RUN
TIME
RPM
Push
Time/RPM
nx10 (RPM)
t (min)
RUN
TIME
RPM
Push
Time/RPM
nx10 (RPM)
t (min)
8
USER'S MANUAL