Makita 3612C Kullanım Kılavuzu - Sayfa 10

Elektrikli Alet Makita 3612C için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 3612C 20 sayfaları. Guide rail adaptor
Ayrıca Makita 3612C için: Parça Dağılımı (3 sayfalar), Kullanım Kılavuzu (16 sayfalar)

Sayfayı Yazdır

1. Bit

2. Base

3. Templet

4. Workpiece

5. Distance (X)

6. Outside diameter of the templet

guide

7. Templet guide

1. Wing bolt (A)

2. Guide holder

3. Fine adjusting screw

4. Wing bolt (B)

5. Wing bolt (C)

6. Trimmer guide

7. Guide roller

Secure the templet to the workpiece. Place the tool on the templet and move

003695

the tool with the templet guide sliding along the side of the templet.

NOTE:

•

The workpiece will be cut a slightly different size from the templet. Allow

for the distance (X) between the bit and the outside of the templet guide.

The distance (X) can be calculated by using the following equation:

Distance (X) = (outside diameter of the templet guide - bit diameter) / 2

Trimmer guide (optional accessory)

003698

Trimming, curved cuts in veneers for furniture and the like can be done easily

with the trimmer guide. The guide roller rides the curve and assures a fine cut.

Install the trimmer guide on the guide holder with the wing bolt (B). Insert the

003700

guide holder into the holes in the tool base and tighten the wing bolt (A). To

adjust the distance between the bit and the trimmer guide, loosen the wing bolt

(B) and turn the fine adjusting screw (1.5 mm per turn). When adjusting the

guide roller up or down, loosen the wing bolt (C). After adjusting, tighten all the

wing bolts securely.