Avantco Equipment 177CHSME32IM Kullanıcı Kılavuzu - Sayfa 4

Mutfak Aletleri Avantco Equipment 177CHSME32IM için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Avantco Equipment 177CHSME32IM 6 sayfaları. Electric cheese melters

Sayfayı Yazdır

Installation

1.
Remove unit from box and make sure all plastic, tape and packing materials are removed.
2. Place the unit on a flat, level, and secure surface with at least 12" of open space around all sides.
3. Check to make sure the outlet of the correct voltage for this item is nearby
4. DO NOT use an extension cord, this item must be plugged directly into an outlet.
NOTE: See optional wall-mounting instructions on page 5.
WARNING
•
The surface of the device becomes hot during operation. The temperature of the device remains high
for some time after the device has been switched off. DO NOT grip heating elements or touch any
surfaces of the device. Use a designated handle to operate the device.
•
You can transport or clean the device only when it has cooled down completely.

Operation

1.
Plug the unit into an outlet of the appropriate voltage. When the unit is plugged in the green power
light will turn ON.
2. Turn the infinite control dial clockwise and set the desired setting, at this time the orange indicator
light will turn ON to indicate the heating element is ON. Allow your unit to pre-heat.
3. Using the bakelite handles, slide out the rack and either place your food directly onto the rack, use a
plate, pan, or sizzle platter to hold the food. We recommend using a sizzle platter or plate to allow for
easy clean up.
4. Using the bakelite handles, lower or raise the rack to the desired height.
a. Use the (4) rack positions for repeatable heating results.
b. Adjusting the height of the rack will affect the intensity of the heat e.g the top rack position will
position your food closer to the heating element, which might result for quicker heating results.
5. Use the 15-minute timer to set desired warming time.
a. These are audible timers and do not turn OFF the machine.
6. When the food or plate has finished heating, slide out the rack, and safely remove the food or plate
from the rack.
a. There is a rack stop, which should prevent the rack from sliding out completely.
7.
When your unit is not in use, we recommend you set it to LOW to maintain residual heat and to reduce
pre-heat time for next use.
www.AvantcoEquipment.com
4
User Manual
Electric Cheese Melters