Makita 3707F Kullanım Kılavuzu - Sayfa 7

Elektrikli Alet Makita 3707F için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 3707F 17 sayfaları. Trimmer
Ayrıca Makita 3707F için: Teknik Özellikler (2 sayfalar), Kullanım Kılavuzu (16 sayfalar), Kullanım Kılavuzu (10 sayfalar), Kullanım Kılavuzu (13 sayfalar)

1. Loosen

2. Tighten

3. Hold

OPERATION

Installing or removing trimmer bit

001983

CAUTION:

•

Do not tighten the collet nut without inserting a bit, or the

collet cone will break.

•

Use only the wrenches provided with the tool.

Insert the bit all the way into the collet cone and tighten the

collet nut securely with the two wrenches. To remove the bit,

follow the installation procedure in reverse.

Set the tool base on the workpiece to be cut without the bit

making any contact. Then turn the tool on and wait until the

bit attains full speed. Move the tool forward over the work-

piece surface, keeping the tool base flush and advancing

smoothly until the cutting is complete.

When doing edge cutting, the workpiece surface should be

on the left side of the bit in the feed direction.

1. Workpiece

3. View from the top of the tool

NOTE:

•

Moving the tool forward too fast may cause a poor

quality of cut, or damage to the bit or motor. Moving the

tool forward too slowly may burn and mar the cut. The

proper feed rate will depend on the bit size, the kind of

workpiece and depth of cut. Before beginning the cut on

the actual workpiece, it is advisable to make a sample

cut on a piece of scrap lumber. This will show exactly

how the cut will look as well as enable you to check

dimensions.

001984

2. Bit revolving direction

4. Feed direction