CORNING LSE 6710 Kullanım Kılavuzu - Sayfa 6

Laboratuvar Ekipmanları CORNING LSE 6710 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. CORNING LSE 6710 12 sayfaları. Digital vortexer
Ayrıca CORNING LSE 6710 için: Kullanım Kılavuzu (9 sayfalar)

Sayfayı Yazdır

The flat mat platform has a circle cut-out in the rubber and screw holes in the center. Remove the

cut-out rubber circle and screw down the 4 screws onto the vortexer. After attaching the platform,

remove the non-adhesive backing paper on the rubber circle, and paste it back into place.

The grease is used to lubricate the slide stabilizers. It is sufficient for 1,000 working hours

(approx. 1 year). After that time you should remove the platform and clean, adjust, and

re-grease the slide stabilizers. If they are worn out, you should replace them with new

stabilizers and set to appropriate height.

5.0 Operating Instructions

5.1 Controls

Power

1. POWER switch: Turns the vortexer ON (power switch illuminates) or OFF.

2. RUN green light: Illuminates when the vortexer is running.

3. TIME yellow light: Illuminates when the vortexer is set on Time.

4. SPEED/RPM yellow light: Illuminates when the vortexer is set on RPM.

5. ENCODER: By rotating the encoder knob right (+) or left (-) you can change the set Time or

RPM. Push the encoder knob to switch between Time and RPM set values. If you rotate the

encoder knob fast, the values go up or down on the display very quickly.

6. START/STOP button: Start or Stop operation.

CO R N I N G L S E D I G I TA L VO RT E X E R

Run

Time

Speed(RPMx10) Time (min)

Speed

ENCODER

PUSH

(Time/Speed)

Start

Stop