Makita 4131 Kullanım Kılavuzu - Sayfa 6

Elektrikli Alet Makita 4131 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 4131 14 sayfaları. Metal cutter
Ayrıca Makita 4131 için: Kullanım Kılavuzu (12 sayfalar), Kullanım Kılavuzu (12 sayfalar), Kullanım Kılavuzu (12 sayfalar), Kullanım Kılavuzu (12 sayfalar)

Sayfayı Yazdır

edge of the panel as shown in Fig. 1.

To minimize the risk of blade pinching and

kickback. When cutting operation requires

the resting of the tool on the workpiece, the

tool should be rested on the larger portion

and the smaller piece cut off.

To avoid kickback, do support board or panel near the

cut.

Do not support board or panel away from the cut.

Do not use dull or damaged blade.

Unsharpened or improperly set blades pro-

duce narrow kerf causing excessive friction,

blade binding and KICKBACK. Keep blade

sharp and clean. Gum and pitch hardened on

blades slows tool and increases potential for

kickback. Keep blade clean by first removing

it from tool, then cleaning it with gum and

pitch remover, hot water or kerosene. Never

use gasoline.

Blade depth and bevel adjusting locking

levers must be tight and secure before

making cut. If blade adjustment shifts while

cutting, it may cause binding and KICKBACK.

ALWAYS hold the tool firmly with both

hands. NEVER place your hand or fingers

behind the tool. If kickback occurs, the tool

could easily jump backwards over your hand,

Fig. 1

Fig. 2

leading to serious personal injury.

Never force the tool. Forcing the tool can

cause uneven cuts, loss of accuracy, and

possible kickback. Push the tool forward at

a speed so that the blade cuts without slow-

ing.

11. Adjustments. Before cutting be sure

depth and bevel adjustments are tight.

12. When operating the tool, keep the cord

away from the cutting area and position it

so that it will not be caught on the work-

piece during the cutting operation. The

tool is provided with a front grip and rear

handle for two hand operation. Operate

with proper hand support, proper work-

piece support, and supply cord routing

away from the work area.

WARNING: It is important to support the

workpiece properly and to hold the tool

firmly to prevent loss of control which

could cause personal injury. Fig. 4 illus-

trates typical hand support of the tool.

A typical illustration of proper hand support, workpiece

support, and supply cord routing.

13. Place the wider portion of the tool base on

that part of the workpiece which is solidly

supported, not on the section that will fall

off when the cut is made. As examples,

Fig. 3

Fig. 4