Makita 4300BV Kullanım Kılavuzu - Sayfa 6

Elektrikli Alet Makita 4300BV için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 4300BV 12 sayfaları.
Ayrıca Makita 4300BV için: Kullanım Kılavuzu (13 sayfalar)

Sayfayı Yazdır

Loosen the bolt on the back of the base with the hex

wrench. Move the retainer so that the roller contacts the

blade lightly. Then tighten the bolt to secure the base

and the retainer.

However, when using the blade that does not have a

straight back, slide the retainer back so that the roller will

not contact the blade.

NOTE:

Occasionally lubricate the roller.

•

Dust cover

009742

CAUTION:

Always wear safety goggles even when operating

•

the tool with the dust cover.

Install the dust cover in a correct position on the tool

using two screws to avoid sawdust scattering..

Rip fence (optional accessory)

005926

When cutting widths of under 150 mm repeatedly, use of

the rip fence (guide rule) will assure fast, clean, straight

cuts. To install it, loosen the bolt on the front of the base.

Slip in the rip fence and secure the bolt.

005927

1. Screw

2. Dust cover

1. Guide rule (Rip

fence)

1. Hex wrench

2. Bolt

Circular guide (optional accessory)

005928

Use of the circular guide insures clean, smooth cutting of

circles under 200 mm in radius. Insert the pin through

the center hole and secure it with the threaded knob.

Move the base of the tool forward fully. Then install the

circular guide on the base in the same manner as the rip

fence (guide rule).

005929

OPERATION

005930

CAUTION:

Hold the tool firmly with one hand on the main

•

handle when using the tool. If necessary, the front

part of the tool may be supported by the other

hand.

Always hold the base flush with the workpiece.

•

Failure to do so may cause blade breakage,

resulting in a serious injury.

Advance the tool very slowly when cutting curves

•

or scrolling. Forcing the tool may cause a slanted

cutting surface and blade breakage.

1. Circular guide

1. Knob

2. Fit pin into the

hole

3. Pin for circular

guide

1. Base

2. Cutting line