CORNING SCF-1728 Manuel - Sayfa 7

Laboratuvar Ekipmanları CORNING SCF-1728 için çevrimiçi göz atın veya pdf Manuel indirin. CORNING SCF-1728 14 sayfaları. Heat shrink open ribbon system (hs-ors) canister splice closure

Sayfayı Yazdır

TPA-6314

10.

Load Express Fibers

IMPORTANT:

Basic ribbon fiber routing requires Ribbon "A" spliced to Ribbon "B." Ribbon "B" will be routed to

the side of the splice plane opposite from Ribbon "A."

• For sub-ribbon splicing, split the ribbon matrix with appropriate equipment (P/N RST-000

or equivalent) and separate ribbon matrix within 6 in of cable sheath opening. Secure this

separation point with tape.

Step 1:

Form the subunits from each cable into a single slack loop placed into the middle storage

compartment of the frame

compartments.

NOTE: Do not yet route any fibers or subunits in the side storage compartment, but rather let subunit lay free

until splicing each subunit.

TPA-6366

(Figure 14)

and cover. Route the extra length toward the side storage

Standard Recommended Procedure 206-455-AEN | Issue 1 | November 2018 | Page 7 of 14

Express cable

Figure 13

Figure 14