Garage1217 Project Solstice Kullanıcı Kılavuzu - Sayfa 8
Amplifikatör Garage1217 Project Solstice için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Garage1217 Project Solstice 14 sayfaları.
Project
Solstice
STEP 2: POPULATE ALL MID SIZE COMPONENTS SUCH AS RCA'S,
POWER COMPONENTS, SMALL CAPACITORS, TUBE SOCKET,
RELAYS, TRIMMERS AND SO FORTH
PLEASE NOTE: CENTER
PIN OF DC SOCKET IS
POSITIVE / 24VDC+
INSTALL SMD INDUCTOR
PRIOR TO INSTALLING
ALL OTHER PARTS IN
THIS STEP. REFER TO
PAGE 9 FOR SOLDERING
GUIDE
INPUT CAPACITORS ARE
NONPOLAR MEANING
THEY HAVE NO STRIPE
AND CAN BE INSTALLED
IN EITHER DIRECTION
POLARIZED CAPACITORS MUST BE INSTALLED IN THE
CORRECT DIRECTION (WILL HAVE A STRIPE DOWN THE SIDE
DESIGNATING POLARITY) INSTALL THIS STRIPE FACING THE
FLAT SPOT ON THE CAPACITOR OUTLINE ON THE BOARD
CORRECT
PEEL OFF THE PROTECTIVE
ADHESIVE LAYER ON THE
BOTTOM SIDE OF THE
HEATSINK(S). PLACE THE
HEATSINKS DIRECTLY OVER
THE THERMAL PADS ON THE
PCB. ONCE INSTALLED, USE A
HAIR DRYER OR HEATGUN TO
BREIFLY HEAT UP EACH
HEATSINK WHICH WILL
ACTIVATE THE ADHESIVE.
CAUTION: IF USING A
HEATGUN, ONLY APPLY HEAT
FOR A FEW SECONDS DIRECTLY
ONTO EACH HEATSINK
INCORRECT