Makita 4329 Kullanım Kılavuzu - Sayfa 7

Elektrikli Alet Makita 4329 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 4329 13 sayfaları. Jig saw
Ayrıca Makita 4329 için: Kullanım Kılavuzu (13 sayfalar), Teknik Özellikler (2 sayfalar), Kullanım Kılavuzu (13 sayfalar), Teknik Bilgiler (7 sayfalar), Kullanım Kılavuzu (13 sayfalar)

OPERATION

CAUTION:

•

Always hold the base flush with the workpiece.

Failure to do so may cause blade breakage,

resulting in a serious injury.

•

Advance the tool very slowly when cutting

curves or scrolling. Forcing the tool may cause a

slanted cutting surface and blade breakage.

Turn the tool on without the blade making any contact

and wait until the blade attains full speed. Then rest

the base flat on the workpiece and gently move the tool

forward along the previously marked cutting line.

► 1 . Cutting line 2. Base

CAUTION:

•

Always be sure that the tool is switched off and

unplugged before tilting the base.

•

Raise the dust cover all the way before making

bevel cuts.

With the base tilted, you can make bevel cuts at any

angle between 0° and 45° (left or right).

Loosen the bolt on the back of the base with the hex

wrench. Move the base so that the bolt is positioned in

the center of the cross-shaped slot in the base.

► 1 . Hex wrench 2. Bolt 3. Base

Tilt the base until the desired bevel angle is obtained.

The edge of the motor housing indicates the bevel

angle by graduations. Then tighten the bolt to secure

the base.

► 1 . Edge 2. Graduation

Front flush cuts

► 1 . Hex wrench 2. Bolt 3. Base

Loosen the bolt on the back of the base with the hex

wrench and slide the base all the way back. Then

tighten the bolt to secure the base.

7 ENGLISH