CORNING NI-3012 Müşteri Talimatları - Sayfa 2

Ağ Donanımı CORNING NI-3012 için çevrimiçi göz atın veya pdf Müşteri Talimatları indirin. CORNING NI-3012 4 sayfaları. Network interface device

KPA-2322

Customer Wiring

Step 1:

Locate terminal to be wired and open cover by sliding orange latch towards the hinge and

lifting up. as shown in Figure 2.

Step 2:

Use a sharp object to puncture a small hole through one of the grommets located in the

bottom left and right of the housing as shown in Figure 3.

Step 3:

Pull wire through the hole in the grommet and extend 3 inches past top of box. Route wire to

terminal to be wired. It is not necessary to strip the wires.

Step 4:

Feed the wires through the hinge of the module

door to the first line position on the left of the

module (Figure 4). Or if desired, remove door to

facilitate wire routing.

Step 5:

Press the orange lever toward the "T R" marking

on the module.

Step 6:

Insert the wires into the tip and ring holes and

press the wires into the wire channels.

Step 7:

Pull the orange lever back to the CONNECT

position (away from the "T R" marking). Gently tug

on wires to check connection.

Step 8:

Repeat for other line connections and close the

module door. Slide the latch all the way to the left.

Tuck extra wire in trough of housing.

Testing

Open cover and plug a working telephone into jack. Normal dial tone shows telephone line is working

properly. If dial tone is not heard, close cover and notify repair service.

Customer Lock

A customer lock #10 Master padlock, or equivalent, may be installed on the network interface for

individual security.

STANDARD RECOMMENDED PROCEDURE 203-297 | ISSUE 2 | MAy 2015 | PAGE 2 OF 4

Orange Latch

Figure 2

TPA-5032

KPA-2327

Figure 3

Figure 4