CORNING SCRN-510 Donanım Kurulum Kılavuzu - Sayfa 16
Ağ Donanımı CORNING SCRN-510 için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. CORNING SCRN-510 17 sayfaları. Small cell radio node
Sayfayı Yazdır12. Radio Node LED Management
The LED display is active by default, but can be deactivated in light-sensitive environments as needed. Even
when the display is disabled, the LED will be lighted during the following conditions:
•
while the radio node is booting
•
if the radio node or cell is in fault state
•
if there is an active emergency call
•
if the locate radio node feature is active
Table 5
shows the default LED behavior of the radio node:
LED
White: slow flashing
Green: slow flashing
Green: fast flashing
Green: solid
Red: solid
Blue: fast flashing
Blue: solid
Off
Note: Refer to the Corning OS (SCOS) Administrator Guide for information about the locate radio node and follow
IMSI features.
12.1 Disabling the LED display
Step 1 From the CLI Configuration Mode, issue the s
command to disable the LED display:
%set System RadioNode LED DefaultMode Dark
Step 2 Issue the
show System RadioNode LED
%show System RadioNode LED
DefaultMode Dark;
12.2 Re-Enabling the LED Display
Step 1 From the Configuration Mode, issue the
command to re-enable the LED display:
%set System RadioNode LED DefaultMode Standard
Step 2 Issue the
show System RadioNode LED
%show System RadioNode LED
DefaultMode Standard;
Corning Restricted and Confidential Proprietary - Controlled content
SCRN-510 Hardware Installation Guide | DOC-SCRN-510-HIG_i4 | 16 October, 2020 | Page 16
Table 5 Radio Node LED Behavior
Status
Software initialization
The radio node or radio is administratively
disabled
Booting
Operational
Fault
Locate radio node enabled (Note)
Follow IMSI enabled
Powered off or LED disabled
Approximately ½ second on, 1½ sec. off
Approximately ½ second on, 1½ sec. off
Approximately 1.4 second on/off cycle
Approximately 1 second on/off cycle
et System RadioNode LED DefaultMode Dark
command to verify the configuration:
set System RadioNode LED DefaultMode Standard
command to verify the configuration:
Flash Rate