CORNING ECL-C4U Talimatlar Kılavuzu - Sayfa 2

Kablolar ve konektörler CORNING ECL-C4U için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. CORNING ECL-C4U 10 sayfaları. Connector housing

Pass-through port

Door

latch

Door stop

KPA-2189

Tools and Materials Required

In addition to the usual complement of tools, you will need 5/16-inch and 3/8-inch nut drivers.

Planning

Before you begin your installation, make sure you understand how the unit is to be installed,

where it will be placed in the equipment rack, where the cables will enter the unit, and how the

jumpers will be routed.

If you plan to route pigtails through one or more of the feed-through ports at the rear of the unit

(for example: to splice into splice trays in another unit), remove the plates covering those ports

at this time. Notice that removing the rear door will simplify lower port plate removal. Slide rear

door to the left to remove it.

Mounting/Grounding the Housing

5.1

Unstubbed Housing

The housing is equipped to mount into a 19- or 23-inch equipment rack with EIA-310 universal

hole spacing.

STANDARD RECOMMENDED PROCEDURE 009-221 | ISSUE 8 | AUgUST 2015 | PAgE 2 OF 10

Connector panels

Jumper routing guides

Jumper trough

Fiber retaining clip

Strain-relief bracket

Entry grommet

Strain-relief bracket

mounting holes

Mounting ear

Figure 2