Makita 4350T Kullanım Kılavuzu - Sayfa 9
Elektrikli Alet Makita 4350T için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 4350T 13 sayfaları. Jig saw
Ayrıca Makita 4350T için: Teknik Özellikler (2 sayfalar), Kullanım Kılavuzu (13 sayfalar), Teknik Bilgiler (14 sayfalar), Kullanım Kılavuzu (13 sayfalar)
The dust nozzle can be installed on either left or right
side of the base.
Then connect a Makita vacuum cleaner to the dust
nozzle.
1
008019
CAUTION:
If you try to remove the dust nozzle forcibly, the
•
hook of the dust nozzle can be diminished and
removed unintentionally during operation.
Rip fence set (optional accessory)
CAUTION:
Always be sure that the tool is switched off and
•
unplugged
before
accessories.
1.
Straight cuts
008020
1
2
3
008021
When repeatedly cutting widths of 160 mm or less, use
of the rip fence will assure fast, clean, straight cuts. To
install, insert the rip fence into the rectangular hole on
the side of the tool base with the fence guide facing
down. Slide the rip fence to the desired cutting width
position, then tighten the bolt to secure it.
1. Dust nozzle
2. Hose for
vacuum cleaner
2
installing
or
removing
1. Rip fence
1
1. Hex wrench
2. Bolt
3. Fence guide
2.
Circular cuts
008022
1
008023
When cutting circles or arcs of 170 mm or less in
radius, install the rip fence as follows.
Insert the rip fence into the rectangular hole on the
side of the base with the fence guide facing up.
Insert the circular guide pin through either of the
two holes on the fence guide. Screw the threaded
knob onto the pin to secure the pin.
Now slide the rip fence to the desired cutting
radius, and tighten the bolt to secure it in place.
Then move the base all the way forward.
NOTE:
Always use blades No. B-17, B-18, B-26 or B-27
•
when cutting circles or arcs.
Guide rail adapter set (accessory)
008024
When cutting parallel and uniform width or cutting
straight, the use of the guide rail and the guide rail
adapter will assure the production of fast and clean cuts.
To install the guide rail adapter, insert the rule bar into
the square hole of the base as far as it goes. Secure the
bolt with the hex wrench securely.
9
1. Fence guide
2. Threaded knob
3. Circular guide
pin
2
3