Makita 4351CT Teknik Bilgiler - Sayfa 6

Elektrikli Alet Makita 4351CT için çevrimiçi göz atın veya pdf Teknik Bilgiler indirin. Makita 4351CT 15 sayfaları. Jig saw
Ayrıca Makita 4351CT için: Teknik Özellikler (2 sayfalar), Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (9 sayfalar)

epair

7. Install Stop ring E-3 to secure Pin 4 as illustrated in Fig. 15.

8. Check whether Slider can reciprocate on Linear guides smoothly.

Note: If Slider does not reciprocate smoothly, Linear guides may lean to the left or the right.

Try again to assemble Linear guides correctly.

Fig. 15

9. Lubricate the parts assembled in Gear housing cover. Refer to [1] Lubrication in page 2.

10. Align Slider to Needle bearing 407 on crank complete, and then assemble Gear housing cover section to Gear housing

as illustrated in Fig. 16. Do not forget to assemble packing between Gear housing cover and Gear housing.

See Fig. 17.

Fig. 16

Fig. 17

Linear guide

Slider

Pin 4

Rod

Needle bearing 407

Slider

Gear housing

cover

Tapping screws CT 4x16

Gear housing cover

Safety wire

Stop ring E-3

Crank complete

Balance plate

Gear housing

Packing

P 6 / 15