Makita 4351FCT Kullanım Kılavuzu - Sayfa 6

Elektrikli Alet Makita 4351FCT için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 4351FCT 13 sayfaları. Jig saw
Ayrıca Makita 4351FCT için: Teknik Özellikler (2 sayfalar), Parça Dağılımı (3 sayfalar), Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (9 sayfalar), Teknik Bilgiler (15 sayfalar)

Sayfayı Yazdır
Makita 4351FCT Kullanım Kılavuzu
Lighting up the lamps
For 4351FCT only
CAUTION:
Do not look in the light or see the source of light
•
directly.
To turn on the lamp, pull the trigger. Release the trigger
to turn it off.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing saw blade
CAUTION:
Always clean out all chips or foreign matter
•
adhering to the blade and/or blade holder. Failure
to do so may cause insufficient tightening of the
blade, resulting in a serious personal injury.
Do not touch the blade or the workpiece
•
immediately
after
extremely hot and could burn your skin.
Tighten the saw blade securely. Failure to do so
•
may cause a serious injury.
When you remove the saw blade, be careful not to
•
hurt your fingers with the top of the blade or the tips
of workpiece.
To install the blade, open the tool opener to the position
shown in the figure.
1
008007
Keeping that situation, insert the saw blade into the
blade clamp as far as the two protrusions of the blade
can not be seen.
operation;
they
may
1. Tool opener
1
2
008008
Return the tool opener to its original position.
After installing, always make sure that the blade is
securely held in place by trying to pull it out.
CAUTION:
Do not open the tool opener excessively, or it may
•
cause tool damage.
To remove the blade, open the tool opener to the
position shown in the figure. Pull the saw blade out
toward the base.
1
be
008009
NOTE:
Occasionally lubricate the roller.
•
Hex wrench storage
008033
When not in use, the hex wrench can be conveniently
stored.
6
1. Blade clamp
3
2. Jig saw blade
3. Protrusions
1. Jig saw blade
1. Base
2. Hex wrench
1
2