CORNING Eclipse Talimatlar - Sayfa 5

Raflar ve Standlar CORNING Eclipse için çevrimiçi göz atın veya pdf Talimatlar indirin. CORNING Eclipse 5 sayfaları. Wall-mount housing

Sayfayı Yazdır

Step 4:

Route the cable and pigtails to an appropriate splicing

surface and perform steps as described in the

instructions for the splice tray and splicing method you

are using.

Step 5:

Once splicing is complete, route cable slack around

the plastic retaining guides inside the storage area and

secure the splice tray into the unit using the retainer

bracket.

10. Cable Routing

Step 1:

Install connectors onto the fibers as per

manufacturing instructions, if nessessary.

Step 2:

Route the fibers inside the housing using the

routing pattern shown, ensuring a minimum

bend radius is maintained.

Step 3:

Clean adapters annd connectors per standard

company practices. Mate connectors in the

adapters.

NOTE: A cable tie and anchor can be used to secure the fibers as

needed.

11. Jumper Installation

Route the jumpers into the unit through either top or bottom holes

in the customer compartment and secure to the strain-relief bracket

using cable ties or the UCC.

12. Door Lock Installation

Step 1:

Remove the double-D knockout from the appropriate door.

Step 2:

Using the locking kit (p/n HDWR-LOCK-KIT), assemble

the components in the orientation shown.

Corning Optical Communications LLC • PO Box 489 • Hickory, NC 28603-0489 USA

800-743-2675 • FAX: 828-325-5060 • International: +1-828-901-5000 • www.corning.com/opcomm

Corning Optical Communications reserves the right to improve, enhance, and modify the features and specifications of Corning Optical Communications products

without prior notification. A complete listing of the trademarks of Corning Optical Communications is available at www.corning.com/opcomm/trademarks. All other

STANDARD RECOMMENDED PROCEDURE 003-499 | ISSUE 4 | SEPTEMbER 2015 | PAGE 5 OF 5

TPA-3004

Tie

wrap

anchor

TPA-3001

TPA-3003

TPA-3006