Makita 5680DWB Kullanım Kılavuzu - Sayfa 4

Elektrikli Alet Makita 5680DWB için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 5680DWB 20 sayfaları. Equipped with electric brake

Sayfayı Yazdır

Specific Safety Rules

DANGER! Keep hands away from cutting area and blade. Keep your second

hand on auxiliary handle, or motor housing. If both hands are holding the

saw, they cannot be cut by the blade.

Keep your body positioned t o either side of the saw blade, but not in line

w i t h the saw blade. KICKBACK could cause the saw t o jump backwards. (See

"Causes and Operator Prevention of Kickback")

Do not reach underneath the work. The guard can not protect you from the

blade below the work. Don't attempt t o remove cut material when blade is

moving .

CAUTION: Blades coast after turn off.

Check lower guard for proper closing before each use. Do not operate saw

if lower guard does not move freely and close instantly. Never clamp or tie

the lower guard into the open position. If saw is accidentally dropped, lower

guard may be bent. Raise the lower guard with the Retracting Handle and make

sure

moves freely and does not touch the blade or any other part, in all angles

and depths of cut.

Check the operation and condition of the lower guard spring. If the guard

and the spring are not operating properly, they must be serviced before use.

Lower guard may operate sluggishly due t o damaged parts gummy deposits,

or a buildup of debris.

4. Lower guard should be retracted manually only for special cuts such as

"Pocket Cuts" and "Compound Cuts." Raise lower guard by Retracting

Handle. As soon as blade enters the material, lower guard must be released.

For all other sawing, the lower guard should operate automatically.

5. Always observe that the lower guard is covering the blade before placing

saw down on bench or floor. An unprotected, coasting blade

will

cause the

saw t o walk backwards, cutting whatever is in its path. Be aware of the time

it takes for the blade t o stop after switch is released.

6. NEVER hold piece being cut in your hands or across your leg. It is important

t o support the work properly to minimize body exposure, blade binding, or

loss of control.

Hold tool by insulated gripping surfaces when performing an operation where

the cutting tool may contact hidden wiring or its o w n cord. Contact w i t h

a "live" wire will also make exposed metal parts of the tool "live" and shock

the operator.

When ripping always use a rip fence or straight edge guide. This improves

the accuracy of cut and reduces the chance for blade binding.

Always use blades w i t h correct size and shape (diamond vs. round) arbor

holes. Blades that do not match the mounting hardware of the saw will run

eccentrically, causing loss of control.

IO.

Never use damaged or incorrect blade washers or bolts. The blade washers

and bolt were specially designed for your saw, for optimum performance and

safety or operation.