Makita 5703R Kullanım Kılavuzu - Sayfa 9

Elektrikli Alet Makita 5703R için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 5703R 13 sayfaları. Circular saw
Ayrıca Makita 5703R için: Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (12 sayfalar), Kullanım Kılavuzu (16 sayfalar)

Sayfayı Yazdır

Adjusting for bevel cuts (Fig. 6)

• Loosen the thumb nuts in front and back, and tilt the

tool to the desired angle for bevel cuts (0 – 45°).

Secure the thumb nuts tightly in front and back after

making the adjustment. (5603R, 5703R, 5903R,

5103R)

• Loosen the thumb nut in front and tilt the tool to the

desired angle for bevel cuts (0 – 60°). Secure the

thumb nut tightly in front after making the adjust-

ments. (5143R)

Sighting (5603R, 5703R) (Fig. 7)

For straight cuts, align the right notch on the front of

the base with your cutting line on the workpiece.

For 45° bevel cuts, align the left notch with it.

Top guide (5903R, 5103R) (Fig. 8)

Align your sight line with either the 0° notch for

straight cutting or the 45° notch for 45° angle cuts.

Top guide (5143R) (Fig. 9)

Align your sight line with either the 0° notch for

straight cutting or the 30° notch for 30° angle cuts or

the 45° notch for 45° angle cuts or the 60° notch for

60° angle cuts.

Switch action (Fig. 10)

To prevent the switch trigger from being accidentally

pulled, a lock-off button is provided. To start the tool,

press the lock-off button and pull the switch trigger.

Release the switch trigger to stop.

CAUTION:

• Before plugging in the tool, always check to see that

the switch trigger actuates properly and returns to

the ''OFF'' position when released.

Operation (Fig. 11)

Hold the tool firmly. Set the base plate on the work-

piece to be cut without the blade making any contact.

Then turn the tool on and wait until the blade attains

full speed. Now simply move the tool forward over the

workpiece surface, keeping it flat and advancing

smoothly until the sawing is completed. To get clean

cuts, keep your sawing line straight and your speed of

advance uniform.

CAUTION:

• The riving knife should always be used except when

plugging in the middle of the workpiece.

• Do not stop the saw blade by lateral pressure on the

disc.

Guide rule (Fig. 12 & 13)

The handy guide rule allows you to do extra-accurate

straight cuts. Simply slide the guide rule up snugly

against the side of the workpiece and secure it in

position with the screw on the front of the base. It also

makes repeated cuts of uniform width possible.

Joint assembly (Fig. 14 & 15 & 16)

(for connecting a vacuum cleaner)

When you wish to perform clean cutting operation,

connect a vacuum cleaner to your tool. Install the joint

on the tool using the screw. Then connect a hose of

vacuum cleaner to the joint.

MAINTENANCE

CAUTION:

Always be sure that the machine is switched off and

unplugged before carrying out any work on the

machine.

To maintain product safety and reliability, repairs,

maintenance or adjustment should be carried out by a

Makita Authorized Service Center.