AVANTEK B06Y21NV8B Kullanıcı Kılavuzu - Sayfa 3

Aksesuarlar AVANTEK B06Y21NV8B için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AVANTEK B06Y21NV8B 5 sayfaları. Doorbell kit

⑤

Battery Compartment

⑥

Battery Compartment Cover

⑦

Mounting Bracket

Features

1. Utilizing a3 V lithium coin cell, the transmitter is estimated to last up to 3 years when used 10 times

per day without battery replacement.

2. The transmitter is IP55 dustproof and waterproof, suitablefor various outdoor environments.

3. The doorbell boasts a massive wireless range of up to 300 m.

4. For enhanced convenience, the receiver is designed with chime selection buttons for easy selection

from amongthe rich selection of 52 chimes. Five volume levels can be easily adjusted using the

volume button.

5. The memory function of the receiver remembers your previous melody and volume level even after

re-installing the battery.

6. The receiver uses 3 AAA batteries and features highly efficient power management for low power

consumption and enhanced battery life.

7. The receiver features a low battery power reminder via LED notification and will check the battery

level each time the battery is replaced.

Installation

Transmitter Battery Unsealing

Before first use, gently pry open the rearcover of the transmitter and peel off the seal on the button cell.

Ensure correct polarity of the battery and close the battery compartment cover.

Transmitter Installation

To ensure sufficient wireless range, do not install the transmitter close to metals.

Adhesive Tape (recommended for water resistance)

1. Clean all surfaces to be used for adhesion with rubbing alcohol.

2. Apply the double-sided adhesive patchtothe back of the transmitter.

3. Remove the outer side of the patch, attach the transmitter tothe desired location and press it

firmly for 30 seconds.

Anchored Screws

1. Gently pry open the rear cover of the transmitter and drill out the marked screw holes.

2. Drill holes for the screws at the desired location and insert the anchors.

3. Attach the rear cover to the wall by tightening it with the screws.

4. To ensure resistance against water, seal the screw holes with silicone.

5. Attach the transmitter onto the screwed-on back cover.

Receiver Installation

Choose an installation location with as few obstacles to the transmitter(s) as possible.

1. Drill holes at the desired location and insert the anchors.

2. Attach the mounting bracket to the wall by tightening it with the screws.

3. Hook the receiver onto the mounting bracket.