Avantes AvaLight-HAL Kullanım Kılavuzu - Sayfa 2

Çalışma Işığı Avantes AvaLight-HAL için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Avantes AvaLight-HAL 3 sayfaları. Tungsten halogen light source

Sayfayı Yazdır
The AvaLight is factory adjusted to optimally focus the output into a 200µm fiber. If lower optical power is
recommended or a different fiber (bundle) diameter is used, the optical power can be adjusted.
1.
Connect your fiber optic spectrometer or your optical power meter to a fiber to the AvaLight-HAL SMA
socket (4) .
2.
Loosen blocking-screw with delivered Allen key (1,3mm).
3.
By shifting the SMA socket you can optimize your optical power.
4.
Secure position by tightening the blocking screw .
1.
Plug out the power connector from the socket.
Remove screw protection caps on the frontside
2.
3.
Loosen 2 screws with philips screwdriver
turn the lightsource upside down
4.
take out the frontplate and lamphouse
5.
remove 2 nylon screws
6.
7.
take out the lamp socket
8.
take out the bulb (carefull, may be hot)
9.
replace by new bulb, do not touch glass with
your fingers
10.
put back lamp socket and nylon screws
Slide back front plate and lamp house, be
11.
carefull not to pinch the electrical wires
12. put back screws and protection caps
24-08-04
Avantes
Adjustment of focusing in SMA fiber
Changing the light source bulb
from lamp socket
AvaLight-HAL manual.doc
www.avantes.com
Lamp socket
Lamp house
Light bulb
2