Avantgarde LBWC-30SB2 Kullanım Kılavuzu - Sayfa 14

Şarap Soğutucu Avantgarde LBWC-30SB2 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Avantgarde LBWC-30SB2 19 sayfaları. Built-in wine cooler
Ayrıca Avantgarde LBWC-30SB2 için: Kullanım Kılavuzu (10 sayfalar)

Sayfayı Yazdır

3. INSTALLATION INSTRUCTIONS

BEFORE USING YOUR APPLIANCE



Remove the exterior and interior packing.



Before connecting the appliance to the power source, let it stand upright for approximately 4 hours. This will

reduce the possibility of a malfunction in the cooling system from improper handling during transportation.



Clean the interior surface with lukewarm water using a soft cloth.

INSTALLATION SPECIFICATIONS



This appliance requires a standard 115 Volt A.C. /50Hz electrical outlet with three-prong ground。



This appliance is designed to be installed built-in or free standing.



Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct

sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Ambient

temperature below 68°F (20°C) or above 90°F (32°C) will hinder the performance of this appliance. This

unit is not designed for use in a garage or any other outside installation.



Avoid locating the appliance in moist areas.



Plug the appliance into dedicated, properly installed-grounded wall outlet. Do not under any circumstances

cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or

grounding should be directed toward a certified electrician or an authorized service center. This unit is not

designed to be installed in an RV or used with an inverter.



After plugging the appliance into a wall outlet, allow the unit to cool down for 3 ~ 4 hours before placing

wine bottles or beverage cans in the appliance.



This wine cooler come with adjustable legs (in the front) to help level the unit

BUILT-IN INSTALLATION

The cutout dimension illustrated in figure (A) allows for door swing and access to the pull-out shelves when

installed as a built-in appliance. If installing between frameless cabinets, a ½" wide filler strip or side panel may

be needed on hinge side. The filler strip will act as a spacer between the appliance case and adjacent cabinet

door swing. The width of the opening must include the filter panels.

Note:

The door should protrude at least 1" beyond the surrounding cabinets.

23"

24 ½"

(door &

handle)

21 ¼"

(without door)

33 3/4"

15-3/4"

min