Makita 6924N Kullanım Kılavuzu - Sayfa 5

Elektrikli Alet Makita 6924N için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 6924N 8 sayfaları. Shear wrench
Ayrıca Makita 6924N için: Kullanım Kılavuzu (8 sayfalar), Kullanım Kılavuzu (20 sayfalar)

Sayfayı Yazdır

Installing the outer and inner

sleeves

Hold the inner sleeve with the pin facing upward. Place

the outer sleeve over the inner sleeve. Press the pin to

allow inserting the inner sleeve, then release the pin to

secure the inner sleeve.

► 1 . Outer sleeve 2. Pin 3. Inner sleeve

Insert the outer and inner sleeves into the tool while

rotating the inner sleeve alternately clockwise and

counterclockwise until there is no gap between the

outer sleeve and the tool. See the figure. Then tighten

the two screws securely.

► 1 . There should be no gap between the outer

sleeve and the tool. 2. Inner sleeve 3. Outer sleeve

4. Screw

OPERATION

Bolt installation

Slip the tool onto the bolt so that the inner sleeve com-

pletely covers the bolt tip.

► 1 . Inner sleeve 2. Bolt tip

CAUTION:

•

Be careful when fitting the sleeve onto the bolt

tip. Striking the tip can damage it so that it will

no longer fit inside the sleeve properly.

•

First tighten bolts preliminarily by using a hand

wrench and then tighten them with this tool. Use

this tool only after preliminary tightening without

starting the tightening with this tool.

Keep forward pressure on the tool while sliding it further

forward until the outer sleeve fits completely over the

nut. If the tool fails to fit completely over the nut, twist

the tool slightly right and left while pushing forward.

► 1 . Outer sleeve 2. Nut

5 ENGLISH