KitchenAid Superba KDS20A Kurulum Talimatları Kılavuzu - Sayfa 6

Bulaşık Makinesi KitchenAid Superba KDS20A için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. KitchenAid Superba KDS20A 6 sayfaları. Built-in

Sayfayı Yazdır

TESTING

INSTALLATION

Remove installation

debris from under dishwasher,

foam door pads on each side and near top of tank, and

all internal

packing material and labels. NOTE:

Do not remove white plastic glides on sides of door or white

plastic bumpers on front corners of lower rack.

Close door and latch handle.

Press "Cancel

Cycle"

button;

timer will automatically

advance to off. Lift

door handle and wait

for timer

to reset itself.

Latch door handle and press "Heavy

Wash" button.

Run

dishwasher

through

the complete

cycle to make certain

it is operating

properly.

Turn off electrical

power,

remove lower panel and check for leaks. Reinstall

lower panel and turn on electrical

power.

CUSTOM WOOD PANELS

If custom wood panels are to be used, they should

l/4"

thick.

Length

and

width

dimensions

should

be the same as front

panel inserts. If wood

panels

are less than

l/4"

thick

they

must

shimmed

up to the required

l/4"

with

proper size

back

board

(corrugated,

masonite,

etc.).

panels are thicker

than

l/4",

the panel edges will

have to be trimmed

down on all four sides.

Refer to Fig. 10 for dimensions

of custom panels

greater

than

l/4"

thick.

For custom

panels l/4"

thick and less, use outside dimensions

only.

When wood

panels are used, heavier door springs,

#C-240418,

should

ordered

required).

CAUTION:

The finish applied to the wooden front

panels should

be applied

to both

the front

and

back sides and all edges, and must be waterproof

since a certain amount

of moist air does discharge

from the machine.

CAUTION

To protect

against possible rupture

of the fill valve, BE

SURE water

lines leading to the dishwasher,

as well as

water

lines

in the dishwasher,

are protected

against

freezing.

Such ruptures are not covered by the warranty.

If the dishwasher

is to be left unused and sujected to

freezing

temperatures,

it must be prepared as follows

avoid fill valve damage: Turn

off electrical

power and

shut off water supply

at the hand valve. Remove lower

panel.

Disconnect

outlet

line at the check valve. This

permits water to drain from the dishwasher

tank, pump

and drain line. Disconnect

both the inlet and outlet

lines

at the FILL

valve.

Make provisions

to control

water

drained

from unit.

Reinstall

lower panel. Turn on elec-

trical power.

Close door and latch handle.

Push "Rinse & Hold"

but-

ton. Allow

machine

to run four or five minutes.

Push

"Cancel

Cycle"

button

and wait for machine

to turn

off. Turn off electricity.

To complete

installation

later:

Remove lower panel.

Connect

drain outlet

line and fill valve (both inlet and

outlet).

Reinstall

lower panel.

Turn on water and electrical

supplies.

KITCHENAID

DIVISION

\HOBART]

TROY,

OHIO

45374

FORM

14405

(1262)

PRINTED

IN U.S.A.

r,;;?j