Makita 7104L Teknik Bilgiler - Sayfa 7
Elektrikli Alet Makita 7104L için çevrimiçi göz atın veya pdf Teknik Bilgiler indirin. Makita 7104L 8 sayfaları. 12-1/4" planer, blade sharpener, plate joiner, chain mortiser, blower, heat gun
Ayrıca Makita 7104L için: Parça Kılavuzu (4 sayfalar), Broşür (1 sayfalar), Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (13 sayfalar)
Sayfayı Yazdır
W
iring diagram
[1] Connecting Lead Wire to Ring Terminal
Route Field lead wire to inside of Polyolefin tube. And then shrink the Polyolefin tube on the end of Ring terminal retainer
to cover the clamping position of the Ring terminal retainer to Field lead wire. See Fig. 22.
Fig. 22
Ring terminal retainer
Field lead wire
[2] Connecting Earth Terminals for Machine and Noise Suppressor
Connect Earth terminals with Motor housing so that each direction is the same as illustrated in Fig. 23.
Fig. 24
Earth terminals
[3] Wiring in Handle at Switch Installation Side
See Fig. 24 below.
Fig. 23
Earth lead wire between motor housing
and terminal block should ride on the
other lead wires and insert into lead wire
holder.
Ring terminal
Polyolefin tube
Earth lead wire for machine
(yellow and green)
Earth lead wire of Noise suppressor
(transparent)
Field Lead wires
(110V: water blue, 220-240V: blue or red)
Handle
Lead wire holder
Noise suppressor
Place line coil, noise suppressor and connector in
the dot circle. After placing Noise suppressor,
install Line coil.
Slacken earth lead wire between motor housing
and terminal block as illustrated.
Terminal
Do not route any lead wires onto the rib
block
for Terminal block.
Connector
Line coil
Slacken earth lead wire of power supply
cord as illustrated.
P 7 / 8