Makita 7104L Kullanım Kılavuzu - Sayfa 7

Elektrikli Alet Makita 7104L için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 7104L 13 sayfaları. 12-1/4" planer, blade sharpener, plate joiner, chain mortiser, blower, heat gun
Ayrıca Makita 7104L için: Parça Kılavuzu (4 sayfalar), Broşür (1 sayfalar), Teknik Bilgiler (8 sayfalar), Kullanım Kılavuzu (13 sayfalar)

Sayfayı Yazdır

1. Indicator plate

2. Indication plate

3. Cutting line (A)

4. Cutting line (B)

OPERATION

1. Hook

1. Hex bolts

2. Gauge plate

3. Travel distance (D)

4. Lever (B)

Turn the setting handle until the front edge of the yellow indicator plate is

006006

aligned with the cutting line (B).

Grasp firmly the grips on either side. Switch on the tool and wait until the cutter

006007

chain attains full speed. Then release the hook and lower the tool head to cut

in the workpiece. Do not apply excessive pressure to the tool. This may not

only decrease the working efficiency but also cause a dangerous reaction.

Feed slowly at the beginning of a cutting operation, at the time of hole break-

through and when cutting a knot in the workpiece. After cutting, gently raise

the tool head until you can hook the tool head back onto the hook. Then switch

off the tool. Raise the lever (A) and remove the tool from the workpiece.

WARNING:

•

Always hook the tool head back onto the hook when not operating the

tool.

•

Never attempt to cut a twisted or warped workpiece which the tool is not

secured firmly to.

Adjusting indicator plate and indication plate

The yellow indicator plate and indication plate are factory adjusted for the

standard equipped cutter chain 16.5 mm. If the alignment is off, for some rea-

son, or when using another size cutter chain, loosen the screws and adjust the

yellow indicator plate and indication plate.

Enlarging hole

Transverse (width) enlargement

006008

A hole can be enlarged transversely by adjusting the gauge plate. Max. expan-

sion of hole width is 15 mm.

NOTE:

•

The gauge plate is factory adjusted for cutting a hole 30 mm wide.

Example:

When cutting a hole 25 mm wide using a cutter chain 16.5 mm,

proceed as follows:

•

Push the lever (B) away from you. Loosen the hex bolts

securing the gauge plate.

•

Adjust the gauge plate so that the travel distance (D) is

8.5 mm; that is, 25 mm - 16.5 mm = 8.5 mm. Tighten the hex

bolts to secure the gauge plate.

•

Cut the first hole with the lever (B) pushed away from you.

Then pull the lever (B) toward you and cut again to enlarge

the hole.