Makita 9207SPB Kullanım Kılavuzu - Sayfa 7
Elektrikli Alet Makita 9207SPB için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 9207SPB 8 sayfaları. Polisher
Ayrıca Makita 9207SPB için: Kullanım Kılavuzu (17 sayfalar), Kullanım Kılavuzu (12 sayfalar), Kullanım Kılavuzu (8 sayfalar)
Sayfayı Yazdır
Never run the tool without the abrasive disc. You
•
may seriously damage the pad.
Hold the tool firmly. Turn the tool on and then apply the
abrasive disc to the workpiece.
In general, keep the abrasive disc at an angle of about
15 degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will result
in poor performance and premature wear to abrasive
disc.
Polishing operation
003475
CAUTION:
Always wear safety glasses or a face shield during
•
operation.
Hold the tool firmly. Turn the tool on and then apply the
wool bonnet to the workpiece.
In general, keep the wool bonnet at an angle of about 15
degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will result
in poor performance and premature wear to wool
bonnet.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
15
1. Limit mark
1
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
003481
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
ACCESSORIES
CAUTION:
These
accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Abrasive discs
•
Wool bonnet 180
•
Rubber pad 170
•
Lock nut 48
•
Lock nut wrench 28
•
Wrench 17
•
Side grip (auxiliary handle)
•
7
1. Screwdriver
2. Brush holder
1
cap
2
or
attachments
Only use
accessory or
are