Jameco Electronics 2168940 Manuel - Sayfa 6

Aydınlatma Ekipmanları Jameco Electronics 2168940 için çevrimiçi göz atın veya pdf Manuel indirin. Jameco Electronics 2168940 13 sayfaları.

Step 10 - Finishing the Lattice

It should look something like this, although mine came out slightly rectangular because I spaced the layers out more than half an inch.

Ultimately, this won't affect animations but it adds a personal effect to it.

Step 11 - Start the Controller

Now let's start on the controller. Start by placing the chip sockets next to each other but to leave enough room for resistors and

headers. I would advise to economize space but to leave yourself enough room to solder and place wires.

Allocate a common GND and VCC line that will connect to each socket. I used small 0.1uF capacitors that are placed in between

each socket for the VCC and GND line. The black wires are for the common GND line. VCC goes to pin 20 and GND goes to pin 10.

Refer to the schematic in Step 12 for the rest of the steps.