KitchenAid W10300929B Kullanıcı Talimatları - Sayfa 10
Bulaşık Makinesi KitchenAid W10300929B için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. KitchenAid W10300929B 19 sayfaları.
Sayfayı Yazdır
®
OPTIONS
CAN BE
WHAT IT DOES
ADDED TIME TO CYCLE
ADDED
SELECTED WITH
WATER
TYPICAL
MAX
GALLONS
(LITERS)
Control Lock
®
or
Avoids unintended use of the dishwasher
between cycles, or cycle and option changes during a cycle.
To turn on Lock, press and hold CONTROL LOCK or 4 HOUR DELAY (depending on model) for 3 seconds. The Control
Lock light will stay on for a short time, indicating that it is activated, and all buttons are disabled. If you press any button
while your dishwasher is locked, the light flashes 3 times. The dishwasher door can still be opened/closed
while the
controls are locked.
NOTE: You may need to disable Sleep Mode by pressing either START/RESUME or CANCEL, or by opening and
closing the door before you are able to turn Control Lock off.
To turn off Control Lock, press and hold CONTROL LOCK or 4 HOUR DELAY (depending on model) for 3 seconds. The
light turns off.
NOTE: If your model requires you to press and hold 4 HOUR DELAY to lock the controls, the Control Lock LED will be
on or off to indicate if Control Lock is active or not.
CONTROL
PURPOSE
COMMENTS
To start or resume a
f the door is Opened during a CYcleorthe power is interrupted the StartJResume indicator
wash cYCle
flashes
The Cycle will not resume until the door is Closed and START/RESUME is pressed.
NOTE" If the Start/Resume button is located on top of door, push door firm!y closed within
3 seconds of pressing START/RESUME, If the door is not closed within 3 seconds, the
StartjResume
button LED wi!l flash, an audib!e tone will be heard, and the cycle will not
start.
To reset any cycle or
options during
selection.
To cancel a wash
cycle after it's
started.
Press and hold CANCEL/DRAIN to reset any control selections made.
See "Canceling A Cycle After Dishwasher Is Started" and "Changing A Cycle After
Dishwasher Is Started" sections.
To turn the audible
Press and h01d the Hi:Temp scrub button foi3 seconds to turn the audible tones on or off.
tones on or off.
Only audible tones for confirming
button presses can be turned on/off. Important audible
tones, such as indicating a cyc!e has been interrupted,
cann0t be deactivated.
t:eedback
CONTROL
PURPOSE
COMMENTS
w:iiillDII,:_ c;_il ; i,,iz:i
The Cycle Status indicator
clean indicatoi glows when a CYcle is finished.
•
,
•
•
Lghtsareusedtofo
owthe
........
.....
If y0u select the Sanl Rinse option, when the Sanl Rinse cycle !s f!nlshed,
progress of me a snwasner
, ,
_ ,
.,
_.
the Sanitized indicator g!ows, lf y0ur dishwasher did not properly sanitize
cycle Locatea on ire front
of ;he dish aslier for front
your dishes, the light flashes at the end of the cyclel This can happen if the
I
w
. ,
,
,
,;
.
,
cycle is interrupted
or the water could not be heated to the [equired
control moaels ana ocaiea
tem-erature
on the top of the door for
P
!
...................
hidden control models.
The Clean and Sanitized lights go offwhen you open and close the door or
)ress
and hold CANCEL
A
The Front Indicator Light or
The light will be blue if the dishwasher is washing or rinsing. The light will
Single Exterior Light (A)
be red when the dishwasher is drying. The light will be green to indicate
shows progress of your
that the cycle is complete. If the Front Indicator Light is blinking, see
dishwasher cycle by color
"Troubleshooting"
section.
(for hidden control models
only).
The
CYcle Status Display is
The indicators Wi!l inform you if you are able to add a dish to the cycle afte r
used to follow the progress
it has started. It wi!l a!so inform you if the dishwasher
is washing, rinsing,
of the dishwasher cycle, and
drying, complete, and/or sanitized. They will show whether the control is
to show other informationl
locked and/or the delay oPtion is se!ected. A series of bars wi!! count down
(Avai abe on some models
the duration of the cycle remaining from left to right. Each bar equals
instead of Cycle Status
approximately
24 minutes of cycle length The bars will a!so count down
Indicator
Lights)the
delay feature from left to right, and the delay indicator wi!! be activated.
10