Makita 9911 Kullanım Kılavuzu - Sayfa 9

Elektrikli Alet Makita 9911 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 9911 17 sayfaları. 76mm
Ayrıca Makita 9911 için: Parça Dağılımı (3 sayfalar), Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (8 sayfalar), Kullanım Kılavuzu (8 sayfalar), Teknik Bilgiler (5 sayfalar), Kullanım Kılavuzu (17 sayfalar)

OPERATION

1. Limit mark

1. Screwdriver

2. Brush holder cap

NOTE:

•

If you connect a Makita vacuum cleaner to this tool,

more efficient and cleaner operations can be performed.

Sanding operation

CAUTION:

•

The tool should not be in contact with the workpiece

surface when you turn the tool on or off. Otherwise a

poor sanding finish or damage of the belt may result.

Hold the tool firmly with both hands. Turn the tool on and wait

until it attains full speed. Then gently place the tool on the

workpiece surface. Keep the belt flush with the workpiece at

all times and move the tool back and forth.

Never force the tool. The weight of the tool applies adequate

pressure. Excessive pressure may cause stalling, overheat-

ing of the motor, burning of the workpiece and possible kick-

back.

CAUTION:

•

Always be sure that the tool is switched off and

unplugged before attempting to perform inspection or

maintenance.

001145

Remove and check the carbon brushes regularly. Replace

when they wear down to the limit mark. Keep the carbon

brushes clean and free to slip in the holders. Both carbon

brushes should be replaced at the same time. Use only iden-

tical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out

003398

the worn carbon brushes, insert the new ones and secure

the brush holder caps.

To maintain product SAFETY and RELIABILITY, repairs, any

other maintenance or adjustment should be performed by

Makita Authorized or Factory Service Centers, always using

Makita replacement parts.