Makita AN942 Kullanım Kılavuzu - Sayfa 9

Elektrikli Alet Makita AN942 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita AN942 17 sayfaları. Pneumatic construction nailer
Ayrıca Makita AN942 için: Kullanım Kılavuzu (20 sayfalar), Parça Dağılımı (3 sayfalar), Teknik Bilgiler (7 sayfalar)

Sayfayı Yazdır

1. Continuos nailing

2. Intermittent nailing

3. Change lever

4. Trigger lock

1. Hammer

2. Small rod

3. Ejection port

4. Driver

1. Pliers

2. Slot

•

For No. 1 method, set the change lever to the "Intermittent Nailing"

004307

position. For No. 2 method, set the change lever to the "Continuous

Nailing" position. After using the change lever to change the nailing

method, always make sure that the change lever is properly set to the

position for the desired nailing method.

Anti dry fire mechanism

•

This tool is equipped with an anti dry fire mechanism. When there are a

few nails remaining in the magazine, the contact arm will be locked in the

undepressed position to prevent the tool from being activated. Load

more nails to resume operation.

Jammed nailer

CAUTION:

•

Always lock the trigger, disconnect the hose and remove the nails from

the magazine before cleaning a jam.

•

When the nailer becomes jammed, do as follows:

•

Insert a small rod or the like into the ejection port and tap it with a

004308

hammer to retract the driver. Use pliers to bend the jammed nail so that

the nail head comes out of the slot in the driver guide. Then remove the

jammed nail.

004309