KitchenAid 36" Kurulum Talimatları Kılavuzu - Sayfa 11

Menziller KitchenAid 36" için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. KitchenAid 36" 16 sayfaları. 30” and 36” gas sealed burner glass cooktops
Ayrıca KitchenAid 36" için: Kurulum Talimatları (5 sayfalar)

Sayfayı Yazdır

Make Gas Connection

1. Assemble flexible connector from gas supply pipe to pressure

regulator located in the middle front of the range.

2. Apply pipe-joint compound made for use with LP gas to the

smaller thread ends of the flexible connector adapters (see B

and G in following illustration).

3. Attach one adapter to the gas pressure regulator and the

other adapter to the gas shutoff valve. Tighten both adapters.

4. Use a

" combination wrench and channel lock pliers to

attach the flexible connector to the adapters. Check that

connector is not kinked.

B C

A. Gas pressure regulator

B. Use pipe-joint compound.

C. Adapter (must have ½" male

pipe thread)

D. Flexible connector

Complete Connection

1. Open the manual shutoff valve in the gas supply line. The

valve is open when the handle is parallel to the gas pipe.

A. Closed valve

B. Open valve

2. Test all connections by brushing on an approved

noncorrosive leak-detection solution. If bubbles appear, a

leak is indicated. Correct any leak found.

3. Remove cooktop burner caps, grates and simmer plate from

parts package. Align notches in burner caps with pins in

burner base. Burner caps should be level when properly

positioned. If burner caps are not properly positioned,

surface burners will not light. Place burner grates over

burners and caps.

A. Burner base

B. Burner cap

C. Burner grate

D. Simmer plate

E. Manual gas shutoff valve

F. ½" or ¾" gas pipe

G. Use pipe-joint compound.

H. Adapter

4. If your cooktop only has surface burners, see "Check

Operation of Surface Burners, Grill and Griddle" section in the

"Electronic Ignition System" section.

5. If your model was shipped with a grill or griddle, see "Install

Grill" or "Install Griddle" section.

Install Grill

(on some models)

1. Remove twist tie and discard. Lift burner assembly out of

basin and set aside.

A. Burner assembly

2. Place drip tray on bottom of grill basin and slide the tray

toward the back so that it is located side to side and against

the locating feet of the rear spill guard.

A. Rear spill guard

B. Locating feet

C. Drip tray

3. Insert the front spill guard feet into the slots in the rear spill

guard. The rear flange will rest on the burner box.

A. Front spill guard

B. Feet and slots