Makita BHR240Z Teknik Bilgiler - Sayfa 5

Elektrikli Alet Makita BHR240Z için çevrimiçi göz atın veya pdf Teknik Bilgiler indirin. Makita BHR240Z 14 sayfaları. Cordless rotary hammer

Sayfayı Yazdır

epair

[3] DISASSEMBLY/ASSEMBLY

[3] -2. Change Lever

DISASSEMBLING

1) Lever up Cap from Change lever using two slotted screwdrivers (Fig. 7).

Note: Lock button and Compression spring 3 will fly away in this step.

Be careful not to lose them.

2) Rotate Change lever fully in the direction of the drill mode position until

the lever is located within the area B (Fig. 8). Change lever can now be

pulled off. Remove O ring 17 from Change lever (Fig. 9).

Fig. 8

Change lever

ASSEMBLING

1) Apply grease to O ring 17 and the pins of Change lever as described in page 3.

2) Put Compression spring 3 and Lock button in place on Change lever. Assemble Cap provisionally to Change lever

as illustrated in Fig. 10 in order to prevent the spring from popping out from Change lever.

Do not forget to assemble O ring 17 to Change lever in this step.

3) Place the provisionally assembled Change lever within the area A of Gear housing (Fig. 8), and insert into the Change

lever installation hole. Change lever cannot be inserted completely in this step.

4) Pushing Change lever against Gear housing, turn Change lever in the direction of the drill mode until it reaches the

area B where it can be completely inserted into the hole. If cannot be completely inserted, do this operation with

Lock button pressed.

5) Turn Change lever to the area C (Fig. 8). Assemble Cap completely to Change lever by pushing in the direction of

Gear housing (Fig. 11).

Fig. 10

Lock button

Compression spring 3

Change lever

Cap

O ring 17

Cap provisionally

assembled to Change lever

Lock button

Cap

Compression

spring 3

Change lever

Fig. 7

= Drill mode

= Rotary hammer mode

= Hammer mode

not protruding

from the surface

of Change lever

Change lever

Cap

Fig. 9

Change lever

Fig. 11

Cap completely

assembled to Change lever

protruding

from the surface

of Change lever

P 5 /14

O ring 17