KitchenAid KDRP707RSS - 30" Pro-Style Dual Fuel Range Kurulum Talimatları Kılavuzu - Sayfa 4

Menziller KitchenAid KDRP707RSS - 30" Pro-Style Dual Fuel Range için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. KitchenAid KDRP707RSS - 30" Pro-Style Dual Fuel Range 16 sayfaları. 30" (76.2 cm) and 36" (91.4 cm) classic commercial-style dual fuel convection range with steam-assist

Sayfayı Yazdır

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the safety instructions provided with any tools

listed here.

Tools needed

Tape measure

Flat-blade screwdriver

Phillips screwdriver

Level

Hand or electric drill

Channel lock pliers

Pipe wrench

Parts needed

A UL listed or CSA approved conduit connector

UL listed wire nuts

Parts supplied

Check that all parts are included.

Anti-tip bracket kit

(2.5 cm)

A. Anti-tip bracket

B. #10 x 2" Phillips head screws (2)

NOTE: Brackets must be securely attached to wall stud.

Thickness of finished wall may require longer screws to anchor

bracket to wall. Longer screws are available from your local

hardware store. See "Install Anti-Tip Bracket" section.

A child or adult can tip the range and be killed.

Connect anti-tip bracket to wall behind range.

Reconnect the anti-tip bracket, if the range is moved.

Failure to follow these instructions can result in death or serious burns to children and adults.

INSTALLATION REQUIREMENTS

" combination wrench

Marker or pencil

Masking tape

Pipe-joint compound

resistant to LP gas

Noncorrosive leak-detection

solution

Stud finder

1¾"

(4.4 cm)

WARNING

Tip Over Hazard

Backguard and attachment screws (7).

NOTE: The backguard included with the range is required if

installed with less than 1" (2.5 cm) clearance from a

combustible rear wall.

Island trim and attachment screws (3).

NOTE: The island trim included with the range may be used if

installed with 1" (2.5 cm) clearance from a combustible rear

wall or with 0" (0 cm) clearance from a noncombustible rear

wall.

LP conversion kit.

NOTE: The cooktop is manufactured for use with Natural gas.

To convert to LP gas, see the gas conversion instructions

provided in the literature package.

Check local codes and consult gas supplier. Check existing gas

supply and electrical supply. See "Electrical Requirements" and

"Gas Supply Requirements" sections.

All electrical connections should be made by a licensed, qualified

electrical installer.

Location Requirements

IMPORTANT: Observe all governing codes and ordinances. Do

not obstruct flow of combustion and ventilation air.

It is the installer's responsibility to comply with installation

clearances specified on the model/serial rating plate. The

model/serial rating plate is located on the vertical surface

below the control panel on the right.

It is recommended that a 600 CFM range hood be installed

above the range.

Recessed installations must provide complete enclosure of

the sides and rear of the range.

To eliminate the risk of burns or fire by reaching over heated

surface units, cabinet storage space located above the

surface units should be avoided. If cabinet storage is to be

provided, the risk can be reduced by installing a range hood

that projects horizontally a minimum of 5" (12.7 cm) beyond

the bottom of the cabinets.

All openings in the wall or floor where range is to be installed

must be sealed.