Gardasoft Vision PP861 Kullanıcı Kılavuzu - Sayfa 15

Kontrolör Gardasoft Vision PP861 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Gardasoft Vision PP861 17 sayfaları. Led lighting controller

Sayfayı Yazdır

1. Serial Commands

A. Error Codes

Error codes may be displayed by the PP860. These are shown as "E nn", where

nn gives the number of the error. The error codes are:

The PP860 has a thermal cutout. If the internal temperature reaches 62

which corresponds to a case temperature of approximately 60

output currents are turned off. This message will persist until the PP860

has cooled down below 60

One of the parameters to a command has an illegal value.

On power up, the stored configuration was invalid.

The RS232 command has the wrong number of parameters.

E16, 17, 18

Invalid command.

E 40

When the unit has powered up the non-volatile memory was corrupt and

has been cleared. Set up the unit again.

All other errors

A hardware error has occurred. Try power cycling the unit and trying

again to see if the fault clears. If not, make a note of the number and

contact your distributor.

c, the