Makita BMR101 Kullanım Kılavuzu - Sayfa 5
Elektrikli Alet Makita BMR101 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita BMR101 9 sayfaları. Job site dab radio
- 1. Important Safety Instructions
- 2. General Safety Rules
- 3. Illustration of General View
- 4. Controls
- 5. Battery Installation
- 6. Scan/Manual Tuning Fm
- 7. Operating the Radio
- 8. Display Modes - FM
- 9. Storing/Recalling Stations in Preset Memories
- 10. Brightness Control
- 11. System Reset
- 12. Specifications
- 13. Maintenance
3-1. Installing or removing the Slide
battery cartridge
3
1
2
• To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into the position. Always insert it all the way until it
locks in place with a little click. If you can see the red
part on the upper side of the button, it is not locked
completely. Insert it fully until the red part cannot be
seen.
• Do not use force when inserting the battery cartridge. If
the cartridge does not slide in easily, it is not being
inserted correctly.
• To remove the battery cartridge, withdraw it from the
tool while sliding the button on the front of the cartridge.
3-2. Installing or removing the Cluster
battery cartridge
1
• To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into position. Always insert it all the way until it locks
in place with a little click.
• Do not use force when inserting the battery cartridge. If
the cartridge does not slide in easily, it is not being
inserted correctly.
1. Button
2. Battery cartridge
3. Red part
1. Battery cartridge
2. Button
2
4. To remove the battery cartridge,
withdraw it from the Job site radio
while pressing the buttons on both
sides of the cartridge. Return the
battery compartment locker in
position to close.
5. Reduced power, distortion and a
"stuttering sound" are all the signs
that the main battery pack needs to be
replaced.
Note:
The battery pack can't be charged via the supplied AC
power adaptor.
Installing the Soft bended rod antenna
1
Install the Soft bended rod antenna as show in the figure.
Using Supplied AC power adaptor
2
Remove the rubber protector and insert the adaptor plug
into the DC socket on the front side of the radio. Plug the
adaptor into a standard mains socket outlet. Whenever
the adaptor is in use, the battery pack is automatically
disconnected. The AC adaptor should be disconnected
from the main supply when not in use.
1. Soft bended rod
antenna
1. DC IN socket
2. Input terminal
(AUX IN1)
1
5