Garde 181CHEESBLKW Kullanıcı Kılavuzu - Sayfa 2

Mutfak Aletleri Garde 181CHEESBLKW için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Garde 181CHEESBLKW 4 sayfaları. Cheese blocker

Please read and comply with the instructions listed on this document. To get the best service life and

performance from your machine, clean it thoroughly before and after each use by following the instructions

listed below. Minimize the use of alkaline cleaners as they may dull the finish and cause pitting.

Operation

1) Place the unit on a sturdy work surface.

2) Using the handle, lift and hold the cutting wire in the upright position.

3) Place cheese block on the cutting surface. Make sure the part of the cheese that is to be cut is on top of

the groove.

4) Gently pull handle so that tension is added to the cutting wire.

5) While maintaining tension on the cutting wire, slowly but firmly lower the handle and press the cutting

wire through the cheese block.

Cleaning and Maintenance

1) Remove the cutting wire.

2) Thoroughly clean the main frame and the cutting wire.

3) Dry all components and re-assemble the unit.

Replace Cutting Wire

1) Firmly grasp the handle with both hands and twist both sides in opposite directions to separate the two

halves. Unhook the cutting wire.

2) On the bottom of the unit, unhook the opposite end of the cutting wire. Remove the old cutting wire

from the unit.

3) Hook one end of the new cutting wire on the bottom of the unit.

4) Wrap the opposite end of the cutting wire around the pulley system. Make sure the wire is placed within

the groove of the pulley wheel.

5) Feed the end of the wire through the gap in the cutting surface and hook the other end of the cutting

wire to the screw located inside the handle.

6) Reconnect both halves of the handle by twisting in the opposite direction that you twisted in step 1.

USER MANUAL