Makita BTS130 Kullanım Kılavuzu - Sayfa 6

Elektrikli Alet Makita BTS130 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita BTS130 12 sayfaları. Cordless oil-impulse driver

Sayfayı Yazdır
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
Reversing switch action
A
1
006798
This tool has a reversing switch to change the direction of
rotation. Depress the reversing switch lever from the A
side for clockwise rotation or from the B side for
counterclockwise rotation.
When the reversing switch lever is in the neutral position,
the switch trigger cannot be pulled.
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the
•
reversing switch lever to the neutral position.
Characteristics of Cordless Oil-impulse Driver
The Makita Cordless Oil-impulse Driver is a hydraulically
operated impact tool using oil viscosity to produce
impacts. Since oil viscosity changes with the temperature,
be aware of the following two points when operating the
tool.
1.
Avoid using the tool below -5 degrees of
temperature. When the tool temperature goes
down below the degrees, this may cause damage
to the motor of tool due to poor impulse.
2.
When the tool becomes too hot, it may take longer
to set screws
3.
The tool can overheat, causing a failure or hand
burn if you operate it continuously for long hours.
Let the tool cool off for more than 30 minutes
before
changing
continuous job.
1. Reversing switch
lever
B
batteries
during
a
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
004521
Use only bits that has inserting portion shown in the
figure.
For tool with shallow bit hole
A=12mm
Use only these type of bit. Follow the
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
006348
For tool with deep bit hole
A=17mm
B=14mm
A=12mm
B=9mm
011405
1.
To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far as
it will go. Then release the sleeve to secure the bit.
long,
1
011406
6
To install these types of bits, follow
the procedure (1).
To install these types of bits, follow
the procedure (2).
(Note) Bit-piece is necessary for
installing the bit.
1. Bit
2. Sleeve
2