Makita DCO140 Kullanım Kılavuzu - Sayfa 8

Elektrikli Alet Makita DCO140 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita DCO140 13 sayfaları. Cordless cut-out tool
Ayrıca Makita DCO140 için: Kullanım Kılavuzu (13 sayfalar), Teknik Bilgiler (8 sayfalar)

Sayfayı Yazdır

When cutting straight line, clamp a straight board firmly

to the material and use it as a guide. Move the tool in

the direction of the arrow with the shoe base flush with

the side of the guide board.

When the cut is complete, turn the tool off and wait for

the bit to stop rotating and then carefully remove it from

the material.

NOTE:

When using this tool, the rotating action causes

•

the tool to pull. The less pressure applied to the

tool causes less pull and provides a more accurate

cut. Excessive pressure or fast cutting can cause

the bit to dull or break premature.

When cutting drywall around outlet boxes, cut in a

•

counterclockwise direction for ease of cut.

The standard bit included with this tool is for

•

cutting drywall only. When cutting materials other

than drywall, do not use the standard drywall

guide bit.

Using multipurpose bit (optional accessory)

014870

When using the multipurpose bit into the material, hold

the tool at approximately a 45 degree angle with the

edge of the shoe base contacting the material.

014871

Bring the tool carefully to a straight position so the shoe

base contacts the material fully.

Circular guide (optional accessory)

Circular cutting diameters: 10 cm - 34 cm

Installing circular guide

014865

Release the thumb screw which secures the shoe.

014866

Align the projections in the circular guide with the

grooves in the shoe, and secure the shoe and circular

guide with the thumb screw.

014867

To adjust the cutting depth, loose the thumb screw and

then slide the shoe with the circular guide. After the

proper adjustment, tighten the thumb screw securely.

Using circular guide

014863

Loosen the knob, and adjust its position in accordance

with the size of the circle to be cut. (The hole

dimensions to be cut are indicated on the side of the

circular guide as a general guideline.) After completion

of the adjustment, tighten the knob securely.

1. Thumb screw

2. Shoe

1. Projections

2. Shoe

1. Thumb screw

2. Circular guide

3. Shoe

4. Loosen

5. Tighten

1. Knob

2. Tighten

3. Loosen