JAMO 3T Kullanıcı Kılavuzu - Sayfa 3

Konuşmacılar JAMO 3T için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. JAMO 3T 9 sayfaları. Indoor/outdoor speakers
Ayrıca JAMO 3T için: Hızlı Kılavuz (4 sayfalar)

Sayfayı Yazdır

Connecting speaker wires

Loosen speaker terminals by turning counter clockwise. Strip ½"/12 mm in-sulation off each

wire. Twist strands on each wire to form "solid" wire.

Insert one wire into each terminal and tighten terminal by turning clockwise. Make sure posi-

tive (+) is to red terminal and negative (-) to black terminal for correct phasing.

Adjustment of I/O 3T

This model is for 70V or 100V line installation. This is mainly used in com-mercial installations

with many speakers and requires an amplifier with matching transformer outputs. A switch

located next to the terminals al-lows for adjustments of the level of the speaker in 10W, 5W,

2.5W and 1.25W settings. Adjust the switch to the desired level on each speaker.

Mounting of speaker

Place the speaker inside the curved bracket as shown in fig. 2 and insert thumb screws (j)

through each end of the curved bracket into the speaker.

Adjust the speaker to the desired angle and tighten the thumb screws.

In-stall the covers (k) over the thumb screws. The curved bracket can be

ad-justed in the wall bracket by loosening the two ½" allen bolts (e) and

re-tighten them after adjustment.

Fig. 2

Painting

The speaker and bracket can be painted. Spray painting is recommended. Paint all parts before

assembling. Remove the grill from the speaker before painting and cover the front baffle (l) of

the speaker. Apply many thin coats instead of a few thick coats to avoid the paint running or

clogging the grill holes. Re-install grill after painting.