HIKVISION DS-9116HFI-ST series Hızlı Kullanım Kılavuzu - Sayfa 8

DVR HIKVISION DS-9116HFI-ST series için çevrimiçi göz atın veya pdf Hızlı Kullanım Kılavuzu indirin. HIKVISION DS-9116HFI-ST series 19 sayfaları. Ds-9100hfi-st series

Sayfayı Yazdır
Quick Operation Guide of DS-9100HFI-ST Series DVR
1. Disconnect pluggable block from the ALARM IN /ALARM OUT terminal block.
2. Unfasten stop screws from the pluggable block, insert signal cables into slots and fasten stop screws. Ensure
signal cables are in tight.
3. Connect pluggable block back into terminal block.
RS-485 Connection
To connect RS-485 devices to the DVR:
1.
Disconnect pluggable block from the RS-485 terminal block.
2.
Unfasten stop screws from the pluggable block, insert signal cables into slots and fasten stop screws. Ensure
signal cables are in tight.
3.
Connect pluggable block back into terminal block.
Note:
Make sure the pan/tilt receiver unit is connected to the T+ and T- of the DVR.
Controller Connection
To connect a controller to the DVR:
1.
Disconnect pluggable block from the KB terminal block.
2.
Unfasten stop screws from the KB D+, D- pluggable block, insert signal cables into slots and fasten stop screws. Ensure
signal cables are in tight.
3.
Connect Ta on controller to D+ on terminal block and Tb on controller to D- on terminal block. Fasten stop screws.
4.
Connect pluggable block back into terminal block.
Note:
Make sure both the controller and DVR are grounded.
7