Lexmark 16H0200 - T 420dn B/W Laser Printer Hızlı Referans - Sayfa 2
Yazıcı Lexmark 16H0200 - T 420dn B/W Laser Printer için çevrimiçi göz atın veya pdf Hızlı Referans indirin. Lexmark 16H0200 - T 420dn B/W Laser Printer 2 sayfaları. Lexmark t420: reference guide
Sayfayı Yazdır
Clearing jams
Jams under the print cartridge or in the fuser
1
Open the upper front door using the finger grips.
To clear the Paper Jam error light and resume printing, you must
remove all jams and press Continue.
The following table may help you locate the jam based on the jam light
sequence. However, you still have to check each possible jam area to
find all the jams.
Jam light sequences
Light sequence
Meaning
Finger grips
2
Remove the print cartridge.
• Ready/Data on
Input jam—see:
• Paper Jam on
• "Jams under the print cartridge or in the
CAUTION!
fuser"
• Press Continue on
• "Jams in a tray"
• Toner Low on
Exit jam—see:
• Paper Jam on
• "Jams under the print cartridge or in the
fuser"
• Press Continue on
• "Jams behind the rear output bin door"
• Toner Low blinks
Duplex jam—see:
• Paper Jam on
"Jams under the printer"
• Press Continue on
Warning!
• Ready/Data blinks
Multipurpose feeder jam:
• Paper Jam on
• Remove any jams in the multipurpose
feeder.
• Press Continue on
3
Remove any jams.
• Make sure any print media in the
multipurpose feeder is loaded correctly.
4
Reinstall the print cartridge.
5
Close the upper front door.
Jams behind the rear output bin door
1
Open the rear output bin door.
2
Remove any jams.
The rear portion of the inside of the printer may
be hot.
You may have to remove the print cartridge to clear a jam in this
area.
Do not touch the photoconductor drum on the
bottom of the print cartridge.
3
Close the rear output bin door.
Jams in a tray
3
Remove any jams.
4
Grasp the tab on the rear door and pull the door open.
1
Gently open the tray until you can see the jam.
2
Remove any jams.
5
Press down the green lever on the right under the printer.
If you see any print media above the metal stop, completely
remove the tray. Press down on the print media to lock the metal
plate below it into place. Reposition the print media under the
metal stop.
6
Remove any jams.
7
Close the rear door, and then reinstall the tray.
Jams in the standard output bin or
multipurpose feeder
Remove any jams from these areas.
3
Reinstall the tray.
Jams under the printer
If you need more information
Print media can jam under the printer and above tray 1 when the
•
Refer to the Setup Guide or the Publications CD for information
duplex function is in use. To clear this type of jam:
about using and maintaining your printer.
1
Completely remove tray 1.
•
Contact your administrator or Help desk if you have questions
2
Press down the green lever on the left under the printer.
about network printing.